Brushed Brass Sockets & Switches

One brushed brass finish across a whole room

Working in brushed brass lets you keep a single warm, low-sheen look running from the socket beside the sofa to the switch by the door. The flat plate sits close against the wall with clean edges, so a row of fittings reads as a set rather than a mix. Pairing sockets, switches and data plates in the same finish is one of the simpler ways to make a refit feel considered.

Sockets, USB and data plates

The range covers 13A switched sockets in single and twin gang, several with dual USB built in so phones and tablets charge without an adaptor taking up the socket. For media corners there are CAT6a network outlets and F-type TV plates, isolated and non-isolated, alongside a 20A flex outlet plate for fixed connections. A dual-voltage shaver socket suits a bedroom or bathroom point.

Switches and dimmers

Toggle and rocker switches run from single up to four gang in two-way wiring, so a busy hallway or open-plan space can be served from one neat plate. An intelligent dimmer gives smooth control over lighting, and a blanking plate tidies any opening left over from a previous layout.

Planning the layout

It helps to walk each room and mark where power, data and lighting controls need to land before ordering. Group sockets near desks and bedside tables, keep switch banks within easy reach of doorways, and allow a USB point or two where devices tend to gather. Free UK delivery over £99, worldwide shipping.

Fitting

Flat plate fittings mount onto standard back boxes, so swapping older plates for brushed brass is usually straightforward. Any work on fixed wiring is best handed to a qualified electrician, who can check the back box depth and earthing before the new plate goes on.