Free Delivery on all orders over £99*

Commercial Speakers

Our range of commercial speakers is built for background music and paging in shops, offices, pubs and yards, where many speakers share a single amplifier. Most use 100V line wiring so levels hold up over long cable runs, and the range covers horn, pendant and sound projector designs alongside standard cabinets. Found it cheaper elsewhere? We will match the price.

Filter By
  • Featured
  • Alphabetically, A-Z
  • Alphabetically, Z-A
  • Price, low to high
  • Price, high to low
  • Date, new to old
  • Date, old to new
119 Products
  • Featured
  • Price, low to high
  • Price, high to low
  • Alphabetically, A-Z
  • Alphabetically, Z-A
  • Date, new to old
  • Date, old to new

Why commercial systems use 100V line

In a shop or an office the problem is not volume, it is distributing a modest amount of sound to a lot of places. A 100V line system sends the signal at a higher voltage and lower current, so it survives long cable runs without losing level, and every speaker carries a transformer with tap settings that decide how much of the amplifier it takes. That means one amplifier can feed dozens of speakers over thin cable, which is far cheaper than wiring each one back as a low impedance pair.

Horn, pendant and sound projector designs

Horn speakers throw sound a long way in one direction and shrug off weather, which makes them the choice for yards, car parks and factory floors where speech has to cut through machinery. Pendant speakers hang from an exposed ceiling and fire downwards, so they suit warehouses, atriums and any space with no accessible ceiling void. Sound projectors mount on a wall or a column and aim along a space, which works well in corridors, platforms and covered walkways.

Planning zones and tap settings

Group the building into zones that need separate control, such as a shop floor, a stockroom and a staff area, then set the tap on each speaker to suit how loud that zone needs to be. Add up the tap wattages of every speaker on a line and keep the total comfortably below the amplifier rating, leaving around 20 per cent headroom. It is better to fit more speakers on low taps than fewer speakers working hard, because the coverage is more even and the sound less intrusive.

Outdoor and industrial areas

Outside, check the IP rating and mount the speaker so water runs off rather than collecting in the horn. Metal horns and treated cones cope with damp far better than untreated paper. In industrial spaces, remember that a hard concrete and steel building reflects sound badly, so more speakers at lower level will always sound clearer than a few loud ones fighting the echo.

Paging, music and voice alarm

A system used for paging needs clear speech above all, so prioritise placement and intelligibility over frequency response. Where music and paging share a system, a mixer amplifier with a priority input will duck the music automatically when a microphone is used. If the system forms part of a life safety or voice alarm installation, that is a regulated area with its own standards, so confirm the specification with your installer before ordering.

Frequently Asked Questions

What does 100V line mean?
The signal is sent at a higher voltage and lower current, so it survives long cable runs without losing level. Each speaker has a transformer with tap settings that decide how much of the amplifier it draws, letting one amplifier feed many speakers over thin cable.

Can I use 100V line speakers with a normal amplifier?
No. They need an amplifier with a 100V line output. A standard low impedance amplifier will not drive them correctly. Some speakers include a bypass to run at 8 ohm instead, but check the specification first.

How do I work out how many speakers one amplifier will run?
Add up the tap wattage set on every speaker and keep the total comfortably under the amplifier rating, leaving around 20 per cent headroom. Fitting more speakers on lower taps gives more even coverage than fewer speakers working hard.

Which design suits an outdoor yard?
A horn speaker. It throws sound a long way in one direction and copes with weather, which is why yards, car parks and factory floors use them. Check the IP rating and mount it so water runs off rather than collecting inside the horn.

What is a sound projector?
A wall or column mounted speaker that aims sound along a space rather than down into it, which suits corridors, platforms and covered walkways where a ceiling speaker is not practical.

Related Collections

BestSellers

Recommended For You

    Our Reviews

    From first click to final installation, our customers share how Niori lights up their spaces. Read their words and envision what’s possible for yours.

    • Free UK Delivery

      Over £99. Ships worldwide.

    • Price Match Promise

      We'll match any like-for-like price.

    • Birmingham Based

      British heritage. Worldwide delivery.

    • Hand-Picked Range

      Beautiful Pieces Selected