Description
Diagonal Wavy Stripes is a white 3D wall panel in PVC, a 50cm square with a relief 15mm deep. Broad raised bands sweep across it from lower left to upper right in long, roughly parallel S-curves. About seven of them fill the panel, each up to about 6cm wide, and some taper to sharp points towards the lower-left and upper-right corners while others run off the edges. The bands make one composition across the whole square rather than a small repeat, so a wall of these 3D wall panels reads as broad, flowing waves, never a busy texture.
We think these panels suit a feature wall behind a bed or sofa, a reception wall in an office or hotel, or the wall behind a counter in a shop. They are made for interior walls, so they sit as happily in a hallway or living room as along an office corridor. In flat, even light the pattern stays quiet, white on white. When daylight or a wall light falls across it from the side, the steep-sided bands throw broad grey shadows and the waves seem to roll across the wall. To work out how many you need, measure the wall: four panels cover one square metre.
Each panel is formed from a 0.8mm PVC sheet. Fitting needs no special equipment: spread adhesive on the back, press the panel onto the wall and cut panels to fit where the wall ends. Fill the joins with filler and wipe off any excess. Adhesive and filler are sold separately. Afterwards they are low maintenance and wipe clean with a damp cloth. For styling, line every panel up so the waves run the same way, then keep the furniture in front low and simple so the pattern has the wall to itself.
Specification
| Pattern |
Diagonal Wavy Stripes |
| Colour |
White |
| Material |
PVC |
| Panel Size |
50 x 50cm |
| Relief Depth |
15mm |
| Sheet Thickness |
0.8mm |
| Coverage Per Panel |
0.25m² |
| Fixing |
Adhesive (Sold Separately) |
| Joins |
Filler (Sold Separately) |
| Suitable For |
Interior Walls |
Frequently Asked
What does the Diagonal Wavy Stripes pattern look like?
About seven broad raised bands sweep diagonally from lower left to upper right in long S-curves, some tapering to sharp points near the corners and others running off the edges.
How big is each panel and how many do I need?
Each panel is a 50 x 50cm square with a relief 15mm deep, and four of them cover one square metre, so measure your wall to work out your number.
How are the panels fixed to the wall?
Spread adhesive across the back of each panel and press it firmly onto the wall. No special equipment is needed, and the joins are finished with filler.
Do I need to buy anything else to fit them?
Yes, you will need adhesive to fix the panels and filler for the joins, as neither comes with the panels themselves.
Can I cut the panels to fit my wall?
Yes. Cut panels to fit where the wall ends or meets a corner, then fix them with adhesive in the same way as a whole panel.
Where can I use these panels and how do I clean them?
They are for interior walls in homes, offices, hotels and shops. They are low maintenance and wipe clean with a damp cloth.