Circle and Two-Way Ribs 3D PVC Wall Panels 50 x 50cm - White

This 3D wall panel is built around a single raised ring at its centre, about half the panel's width across. The ring holds a plain half-disc on its left and a run of short vertical ribs on its right. Rounded ribs with rounded ends fill the rest of the square, set close together, running vertically across the left half and horizontally across the right half. Where they reach the ring they stop short in neat steps, leaving a narrow gap so the circle stands clear. The relief is 6mm deep, so the shadows along each rib stay soft and defined rather than heavy. The panel is white PVC, a 50cm square.

Our Circle and Two-Way Ribs 3D wall panels suit interior walls in homes, offices, hotels and shops. Laid as a feature wall, they repeat the ring along its length, and the switch between vertical and horizontal ribs gives a woven rhythm that reads well from across a room. Behind a bed, along a reception desk or facing a shop entrance, the pattern stays crisp without shouting. Light changes it through the day: a window or wall light to one side picks out every rounded rib and the edge of the ring, while flat, even light lets it settle into a quieter texture.

Each panel is made from a 0.8mm sheet. Fitting needs no special equipment: spread adhesive on the back, press the panel onto the wall and cut panels to fit at edges and corners, then fill the joins with filler and wipe them clean. Adhesive and filler are sold separately. Four panels cover one square metre, which makes working out how many your wall needs straightforward. They wipe clean with a damp cloth and need little maintenance. For the strongest effect, light the wall from one side, and keep what stands in front of it simple so the ring and ribs do the work.

What does the Circle and Two-Way Ribs pattern look like?

A raised ring sits at the centre of each panel, holding a plain half-disc and short vertical ribs. Rounded ribs run vertically across the left half and horizontally across the right.

How big is each panel and how many will I need?

Each panel is a 50 x 50cm square, and four of them cover one square metre, so measure your wall and work from there.

How are these 3D wall panels fixed to the wall?

You spread adhesive on the back of each panel and press it onto the wall, then fill the joins with filler and wipe them clean. No special equipment is needed.

Do the panels come with adhesive and filler?

No. The adhesive and the filler are each bought on their own, so have both ready for the back of the panels and the joins before you start fitting.

Can I cut the panels to fit my wall?

Yes, they can be cut to fit where a wall ends or meets a corner, and the joins are then filled with filler and wiped clean for a tidy finish.

How do I clean the panels?

Wipe them over with a damp cloth whenever dust settles along the ribs or around the ring. They are low maintenance.