Spark LED Pendant Light 7W 3000K - Sand Black

The Spark is an 85mm diameter cylindrical LED pendant light finished in sand black, built around an integrated 7W LED module producing 530 lumens at 3000K warm white. The pendant consists of a matt black metal cylinder paired with a clear upper section that houses an internal cone-shaped diffuser, which refracts the LED output downwards and outwards in a controlled spread.

Designed for contemporary residential and hospitality interiors, the Spark works over kitchen islands, dining tables, bar counters and reception desks where compact downward task light is needed without the visual weight of a larger shade. The adjustable drop ranges from 285mm minimum to 1785mm maximum, allowing the pendant to be set at the correct height for a 700-900mm clearance above a worktop or table surface. The slender 85mm profile means multiple units can be grouped in a linear run over an island without crowding the visual field.

The sand black finish is a textured matt coating applied to the metal housing, providing grip for light absorption and a low-reflectance surface that keeps attention on the light output rather than the fitting itself. The clear upper section reveals the internal cone diffuser, which prevents glare from the LED chip while distributing the 530 lumens across a broader cone than a bare LED would produce. At 0.4kg the pendant is light enough to hang from standard UK ceiling roses without reinforcement.

Is the Spark dimmable?

No. The integrated 7W LED module is not dimmable and runs at fixed output when switched on. If dimming is required, consider other pendant models in the Mantra range that specify dimmer compatibility.

How bright is 530 lumens?

530 lumens from a 7W LED is roughly equivalent to a 40-50W incandescent bulb. This provides adequate task light over a kitchen worktop or dining table when the pendant is hung 700-900mm above the surface, but is not designed as primary ambient lighting for a large room.

Can multiple Spark pendants be installed in a row?

Yes. The compact 85mm diameter makes the Spark well-suited to linear groupings over kitchen islands or bar counters. Typical spacing is 400-600mm between centres, with the pendants wired to a single switch or separate circuits depending on the installation.

What ceiling height is needed for the maximum 1785mm drop?

For a 1785mm drop with the pendant hung 700mm above a worktop, a ceiling height of approximately 2.5m or above is needed. Most residential kitchens with 2.4m ceilings will use a shorter drop, adjusting the cable length during installation.