Sabik MINI 0.8W 12V LED Step Light Cool White - Black

The Sabik MINI is a recessed LED step light that marks indoor stairs, landings and walls with a low, glare-free glow. It draws just 0.8W on a 12V DC supply, putting out 14 lumens at a 4000K cool white tone, so the light defines the edge of a tread or the line of a corridor without lighting the whole room. Buyers in the US will know this format as a recessed step or stair light, a small square fitting that beds into the wall rather than sitting proud of it. At 75 by 75 mm on the face, it keeps a tidy, near-flush profile.

The Sabik MINI suits stairwells, hallways and split-level landings indoors, where a run of these set at skirting or tread height keeps a route readable underfoot at night. It is not a room light, so think of it as edge marking and orientation rather than general brightness. The throw is a soft downward wash across the immediate tread or floor, enough to pick out a step without dazzling anyone descending. Several units spaced along a flight or a passage give an even line of guidance, and the small footprint lets them tuck into walls where a larger fitting would not fit.

Built with a polished stainless steel face and a plastic body, the Sabik MINI carries an IP20 rating, so it is for dry indoor positions only and should be kept out of bathrooms, porches and any exposed outdoor location. It runs from a 12V DC supply and recesses into the wall, which means a suitable transformer or driver is needed to step mains down to 12V. The fitting is not dimmable. The fixed 4000K output and 50,000 hour rated lifespan keep maintenance low. The finish here is black, and the Sabik range carries further step and ground fittings to match across a scheme.

Does it need a 12V transformer or driver?

Yes. The Sabik MINI runs on 12V DC, so it must be wired through a suitable transformer or driver that steps mains voltage down to 12V. It cannot be connected directly to a mains supply.

Can it be used outdoors?

No. This fitting is rated IP20, which covers dry indoor use only. Keep it clear of bathrooms, porches, gardens and any damp or exposed position, and use it on indoor stairs, landings and walls instead.

How is it installed?

It is a recessed mount fitting that beds into the wall, sitting close to flush with a 75 by 75 mm square face. You will need a suitable recess and a low-voltage feed at the chosen height, typically near tread or skirting level on a stairway.

How should it be cleaned?

Wipe the polished stainless steel face with a soft, dry or slightly damp cloth to keep the lens clear. Avoid abrasive cleaners, and switch the fitting off at its low-voltage supply before wiping it down.