Ontec S 3.6W Self-Test Emergency Light - Surface 20m IP65 - White

The Ontec S is a surface-mounted LED emergency light fitting rated at 3.6W and delivering 371 lumens at a crisp 5000K. It runs from a 220-240V AC supply and is built to mark escape routes clearly during a mains failure, with a spacing capability of up to 20m between fittings on a corridor run. As an emergency luminaire it does the job an emergency exit light covers in US terms, holding its battery-backed output to keep the way out visible rather than lighting a room.

The fitting suits commercial and industrial sites where a clear escape route is a requirement: corridors, stairwells, plant rooms, loading bays, car parks and external walkways. Because this is escape-route marking rather than general room lighting, the relevant measure is how far the light reaches along a path, and the 20m spacing means fewer units are needed across a long run while keeping the route legible. Its surface mounting works on either a wall or a ceiling, so it can be positioned at the points where people make decisions about direction during an evacuation. The IP65 rating means it can be fitted in damp and fully exposed positions that an indoor-only fitting could not cover.

The body is moulded plastic in a white finish and weighs 336g, keeping it light enough for straightforward surface fixing. The IP65 sealing makes it weatherproof for exposed outdoor and wet locations, including direct water from hose-down cleaning. A self-test function runs the battery and lamp checks automatically, cutting the routine manual testing burden across a site. This fitting sits within the wider Ontec S range, so matching emergency units can be specified for a consistent install.

Is this a maintained or non-maintained emergency light?

The Ontec S operates as a non-maintained emergency fitting, meaning it stays off in normal conditions and only illuminates when the mains supply fails. This is the usual choice for escape routes that have their own everyday lighting. The integral battery keeps the LED running to mark the way out during an outage.

How does the self-test function work?

The fitting carries out its own battery and lamp tests automatically on a set cycle, so staff do not have to trigger each check by hand. This reduces the manual testing workload across a larger installation and helps keep records consistent. Any fault is flagged so the unit can be attended to.

Can it be installed outdoors or in wet areas?

Yes. With an IP65 rating it is weatherproof and suitable for fully exposed outdoor positions and wet locations, including walkways, car parks and areas subject to washdown. It can be surface mounted on a wall or ceiling at the relevant escape points.

How do I clean the fitting?

Wipe the sealed plastic body and lens with a soft damp cloth to clear dust and grime that can dim the output. Avoid solvents that could mark the white finish. The IP65 sealing means light cleaning will not let water into the unit.