Omnio Dimmable LED Round Wall Light 34W 3000K - White

The Omnio is a dimmable LED wall light built around two overlapping circles: a 37cm aluminium ring in matte white and a smaller opal acrylic diffuser that sits partially nested below. The integrated 34W LED delivers 1687 lumens at 3000K through the opal diffuser, casting an even wash of warm white light across the wall and into the room without visible hotspots or glare.

Designed for hallways, bedrooms, living rooms and landings where ambient light is needed without ceiling fittings, the Omnio mounts flush to the wall with a 6cm projection. The overlapping circular geometry gives the fitting a sculptural presence in daylight and a balanced glow when lit. Dimmable via a compatible wall dimmer or leading-edge control, the output can be reduced to suit evening use or increased for task visibility.

The matte white aluminium finish sits neutrally against white and light-grey walls while providing a defined edge where the circles overlap. The IP20 rating limits the fitting to dry indoor rooms — bedrooms, hallways, living areas — and excludes bathrooms or outdoor use. At 1.37kg the fitting requires secure wall fixings into masonry, plasterboard anchors or timber studs rather than hollow-cavity fixings alone.

Schuller manufactures the Omnio in Spain as part of a range of geometric LED wall lights. The 37cm width suits standard residential hallway and bedroom walls without dominating smaller spaces, and the 53cm height provides vertical balance where the wall height allows.

Product Specification Sheet

Assembly Instruction

Is the Omnio dimmable?

Yes. The integrated LED is dimmable via a compatible leading-edge or trailing-edge wall dimmer. Dimmer compatibility depends on the specific dimmer model — consult the dimmer manufacturer's compatibility list or contact us before pairing.

What rooms can it be used in?

The IP20 rating limits the Omnio to dry indoor rooms: bedrooms, living rooms, hallways, landings. It cannot be used in bathrooms, kitchens near sinks, or outdoors.

What wall fixings are needed?

At 1.37kg the fitting requires secure wall fixings. Use masonry anchors for brick or concrete, plasterboard anchors rated for at least 2kg, or screws into timber studs. Hollow-cavity fixings alone are not sufficient.

Can the LED be replaced?

The LED is integrated and not user-replaceable. The rated lifespan is typically 25,000-30,000 hours at full output, which translates to approximately 10-12 years of typical domestic use at 6-8 hours per day.