MAH MAX 1180x80 38W LED Batten IP66 110 deg Cool White - Grey

The MAH MAX is a 38W LED batten light measuring 1180x80 mm, putting out 6080 lumens of 4000K cool white through a wide 110 degree spread. American buyers will recognise the format as an LED shop light, the long surface-fixed tube that lines garages and storage bays. It runs straight from 220-240V AC mains and uses an integrated LED array rated to 50,000 hours, so there is no tube or starter to swap over its life. The neutral cool white tone keeps colours clear and the output crisp across a working area.

At 6080 lumens this batten covers around 20 m² at general lighting levels, which makes it a sound single-fitting choice for a standard garage, workshop bay, utility room or store. The IP66 rating means it copes with exposed outdoor positions and washdown areas as readily as a dry indoor ceiling, so a covered car port, plant room or damp basement all suit it. The 110 degree beam throws light broadly rather than in a tight line, and the rectangular body sits flush against a ceiling or wall without dropping far into the space. Fittings of this length are often run end to end across a longer room to even out the light.

The housing is polycarbonate finished in grey, with an IK08 impact rating that holds up to the knocks of a busy working environment. The IP66 seal keeps dust and water jets out, which is what lets it sit outdoors or in wet utility settings. It mounts directly to a ceiling or wall surface and is not dimmable, running at full output whenever switched on. The driver is built in, so it wires straight to mains with no separate gear to source. Our wider Mah batten range includes other lengths and wattages if you need to match output across a larger run.

Where is this batten best used?

It suits garages, workshops, car parks, store rooms and damp utility spaces. The IP66 rating also allows exposed outdoor and washdown locations, so it works well in plant rooms, covered car ports and basements where moisture is a factor.

Is it weatherproof enough for outdoor use?

Yes. The IP66 rating means it is fully protected against dust and high-pressure water jets, so it is rated for exposed outdoor and wet locations as well as dry indoor ceilings. Mount it securely to a sound surface and wire it to the 220-240V AC mains supply.

Can several be linked together in a run?

Battens of this type are commonly installed end to end to light a longer space evenly. Each fitting wires to the mains independently, so check the spacing against the 6080 lumen output and 110 degree spread to keep the coverage consistent along the room.

How do I clean it?

Wipe the polycarbonate body with a soft damp cloth and a mild detergent, then dry it off. Isolate the supply first and avoid abrasive cleaners or solvents that could mark the grey finish or the diffuser surface.