Description
The Linus LED is a slim rectangular ceiling fitting that runs on 4W and puts out 390 lumens at a neutral 4000K white. At just 270 x 31 x 22 mm it is a compact, low-profile unit, drawing 220-240V mains and reaching 98 lm/W for an efficient, even spread of light. American buyers searching for a flush mount LED ceiling light will recognise the format: an integrated LED panel sits behind the diffuser, so there is no separate bulb to fit or replace. The light is fixed at 4000K, a clean neutral tone that sits between warm and cool.
Being a modest output, the Linus suits small and transitional spaces rather than main rooms. Think hallways, landings, cupboards, porches with mains protection indoors, utility corners and small bathrooms where it is mounted in a dry zone away from water. At general lighting levels it covers around 1 m², so it works best as accent or supplementary light, or paired in a run along a corridor. With its narrow rectangular profile it suits lower ceilings well, sitting close to the surface without dropping into the room. As an IP20 fitting it is for dry interior use only, so keep it clear of bathrooms zones near the shower or basin and away from any outdoor position.
Construction is a white plastic body with a matching diffuser, weighing only 142 g, which makes handling and mounting straightforward. The integrated LED is rated for 30,000 hours and the unit is not dimmable, so it pairs with a standard on/off switch rather than a dimmer circuit. It can be fixed to either wall or ceiling, giving flexibility in tight spaces, and the neutral 4000K output stays consistent across its life. The finish is a plain white that blends into most ceilings and walls. The Linus is part of a wider Niori range if you need matching fittings across several rooms.
Specification
| Power |
4W |
| Voltage |
220-240 AC |
| Luminous flux |
390 lm |
| Efficiency |
98 lm/W |
| Colour temperature |
4000K |
| Colour rendering (CRI) |
Ra 80 |
| IP rating |
IP20 |
| Dimmable |
No |
| Mounting |
Wall Mounted, Ceiling Mounted |
| Lifespan |
30,000 hours |
| Shape |
Rectangular |
| Dimensions |
270 × 31 × 22 mm |
| Weight |
142 g |
| Material |
Plastic |
| Finish |
White |
Downloads
Frequently Asked
How big a room will the Linus light?
At 390 lumens this is a low-output fitting, covering around 1 m² at general lighting levels. It is best suited to small spaces such as hallways, landings and cupboards, or used in multiples along a corridor rather than as the sole light in a main room.
Is the Linus dimmable?
No, this fitting is not dimmable and should be used with a standard on/off switch. Wiring it to a dimmer circuit can cause flicker or shorten the life of the LED, so a plain switch is recommended.
Does it take a replaceable bulb?
No, the Linus uses an integrated LED rather than a changeable bulb. The light source is built into the fitting and rated for 30,000 hours, so there is nothing to swap out during normal use.
How do I clean the diffuser?
Switch the fitting off and let it cool, then wipe the white diffuser with a soft, dry or slightly damp cloth. Avoid solvents or abrasive cleaners on the plastic, as these can dull or scratch the surface over time.