Itech M2 302MATW 2W Ø170 Surface Emergency Light IP65 - White

The Itech M2 302MATW is a round surface-mounted emergency led light running on 220-240V AC mains, drawing 2W and putting out 270 lumens at a crisp 5000K cool white. It measures Ø170 by 66.5mm and mounts to either a wall or a ceiling, sitting close to the surface with its circular plastic housing. In US terms this is the kind of emergency light fitting specified to mark a safe route the moment the supply fails, with the cool tone helping signage and exit paths read clearly under low light.

This fitting is built for escape routes, stairwells, corridors and plant rooms, and its IP65 rating extends that to car parks, loading bays and external doorways where rain and dust reach the fitting. Coverage is best judged by where it needs to be seen rather than by an area figure, so position it to mark direction changes, doorways and level changes along the escape path. The compact Ø170 footprint keeps it discreet on a wall or overhead, and the 5000K output gives a bright, neutral wash that picks out the route during an evacuation.

The body is moulded plastic in a white finish, sealed to IP65 so it copes with splashing, jets and wet exposure outdoors as well as damp utility areas. It surface-mounts directly to the wall or ceiling, with no recessed cut-out required, making it straightforward to fit onto a finished surface. The integrated battery drives the LED when mains power is lost, and the fitting is part of the wider Itech emergency range, which Kanlux supplies in matching variants for different output and duration needs.

Is this a maintained or non-maintained emergency light?

The M2 302MATW is an emergency luminaire that illuminates when the mains supply fails. Confirm the maintained or non-maintained operating mode against the product datasheet for your installation, as this determines whether it stays lit in normal use or only on power loss.

How long does it stay lit on battery?

Emergency fittings of this type are designed to provide illumination for a set duration once the mains supply is interrupted, typically to cover the time needed to evacuate safely. Check the rated battery duration on the spec sheet to confirm it meets the requirement for your escape route.

Can it be used outdoors or in wet areas?

Yes. The fitting carries an IP65 rating, so it is suitable for fully exposed outdoor positions, external doorways, car parks and damp utility spaces where rain and dust reach the fitting. The sealed plastic housing keeps water and dust out of the LED and battery.

How do I keep it clean?

Wipe the white plastic housing and lens with a soft, damp cloth to remove dust and grime that can dull the output. Avoid abrasive cleaners or solvents, which can mark the finish, and make sure the fitting is dry before relying on it again.