Erinus Ø80 0.8W Recessed Step Light Cool White - White

The Erinus is a recessed LED step light that sits flush within the wall, casting a soft downward wash to mark stairs and low-level routes. It draws just 0.8W at 12V DC and puts out 15 lumens at 4000K, a cool white tone that reads cleanly against pale walls and timber treads. American buyers will know this format as a recessed step light or stair-marker. The round face measures Ø75 mm, and the low output is intended for guidance and edge definition rather than full illumination.

This fitting suits indoor stairwells, landings, hallways and along the base of internal walls where a foot-level glow keeps steps visible without a bright overhead source. Because the light is a low-level marker rather than ambient room lighting, think of it in terms of throw: a gentle pool across one or two treads and the floor immediately below, ideal for spacing in a run up a staircase. With an IP20 rating it is for dry indoor positions only, so keep it clear of bathrooms, porches and any outdoor or damp setting.

Built from white plastic in a round profile, the Erinus recesses into the wall via a back box, giving a tidy fascia with no visible fixings. It runs on a 12V DC supply, so a suitable transformer is needed to step mains down to low voltage. The fitting is non-dimmable and rated for around 30,000 hours, with the LED integrated rather than replaceable. The white finish keeps it unobtrusive. The Erinus range includes other low-voltage step and ground markers in matching tones.

Does it need a 12V transformer?

Yes. The Erinus runs on 12V DC, so it must be wired through a suitable transformer or driver that steps mains voltage down to 12V. Several fittings can usually share one transformer provided its rated output covers the total load.

Can it be used outdoors?

No. This fitting is rated IP20, which means dry indoor use only. It is suited to internal stairs, landings and hallways, and should not be fitted in bathrooms, porches or any outdoor or damp location.

How is it installed?

It is a recessed mount, sitting flush within the wall via a back box so the round Ø75 mm face is the only visible part. Position it low, typically near skirting or tread height, to wash light across the steps below.

How do I clean it?

Wipe the white plastic fascia with a soft, dry or barely damp cloth. Avoid solvents and harsh cleaners, which can mark the finish, and never use a soaking wet cloth given the indoor electrical fitting.