Beno Eco 12W Ø200 Round LED Ceiling Light Colour Selectable IP65 - White

The Beno Eco is a round LED ceiling light running 12W direct from 220-240V AC, with the LED board built in rather than a replaceable lamp. Output is colour selectable across 3000K warm white, 4000K neutral white and 6500K cool white, giving roughly 1200 to 1300 lumens depending on the tone chosen. A wide 110 degree beam spreads the light evenly across the area below, and at 200mm diameter it sits close to the surface. North American buyers shopping for a flush mount LED ceiling light will recognise the same low-profile form factor here.

Around 1200 lumens covers about 4 m² at general lighting levels, which suits a porch, a small bathroom, an entrance lobby, a utility area or a covered walkway. It works well on standard ceiling heights where a low-profile fitting is wanted close to the surface, and the IP65 rating means it can also go on a wall in the same exposed or damp positions. For larger rooms you would pair two or more units to keep the spread even, since a single fitting is sized for compact spaces.

The body is moulded polycarbonate finished in white, sealed to IP65 so it stands up to direct water and dust in fully exposed outdoor and wet locations. It mounts either to a ceiling or a wall, and the colour temperature is set on the fitting itself rather than over a separate control. This is a non-dimmable fitting rated for 30,000 hours, with the driver gear contained inside the housing so no external transformer is needed. Other Beno Eco sizes and wattages are stocked alongside this one through our range.

What size room does it suit?

At around 1200 lumens it lights about 4 m² at general levels, so it is sized for compact spaces such as a porch, small bathroom, lobby or utility area. For a larger area, fit two or more units to keep the light even across the space.

Can it be used outdoors and in wet areas?

Yes. The fitting is rated IP65, which means it is sealed against dust and direct water jets, so it is suitable for fully exposed outdoor positions and wet indoor locations such as bathrooms and covered walkways. It can be mounted on either a ceiling or a wall in those settings.

How do I change the colour temperature?

The colour temperature is selected on the fitting between 3000K warm white, 4000K neutral white and 6500K cool white. There is no separate controller to wire in, so you set the tone you want during installation.

How do I clean it?

Wipe the white polycarbonate cover with a soft, damp cloth and a little mild detergent, then dry it off. Avoid abrasive pads or solvents, which can dull the surface, and switch the light off at the wall before cleaning.