Beno Ø220 12-18W PIR LED Ceiling Light IP65 Colour Selectable - White

The Beno is a round LED ceiling light with a built-in PIR sensor, switching between 12W and 18W to deliver up to 2080 lumens. Its 110 degree beam spreads light broadly across the space below, and the colour selectable output runs across 3000K, 3500K and 4000K so the tone can be set from a warm domestic feel to a cooler, more neutral white. American buyers will recognise this format as a flush mount LED ceiling light, sitting close to the surface rather than hanging. The integrated LED is fixed within the fitting, so there is no separate bulb to replace over its life.

Measuring 220mm across and just 57mm deep, the Beno suits hallways, porches, utility rooms and covered entrances where motion-triggered light is useful. At general lighting levels it covers around 6 to 7 m², which makes it a sensible choice for a small landing, a single-car garage bay or a sheltered doorway. The low 57mm profile keeps it discreet on lower ceilings, and the PIR detection means the light responds as someone approaches rather than running constantly. For wall positions the same sensor coverage applies, so it works above a back door or along a passage as readily as overhead.

Built from polycarbonate with a white finish, the Beno carries an IP65 rating, so it stands up to exposed outdoor and wet locations as well as damp indoor sites. The fitting can be wall or ceiling mounted, fixing flat against the surface, and runs on a 220-240V AC supply with no external driver to specify. It is not dimmable, which keeps the wiring simple, and the integrated LED is rated to 50,000 hours. The Beno range includes further sensor and standard versions of this fitting for matching across a property.

What size room does it suit?

With up to 2080 lumens and a wide 110 degree beam, the Beno covers around 6 to 7 m² at general lighting levels. That makes it well matched to hallways, porches, small utility rooms and single garage bays. For larger areas you would use more than one fitting.

Can it be used outdoors?

Yes. The Beno is rated IP65, which makes it weatherproof and suitable for exposed outdoor and wet locations as well as damp indoor sites such as bathrooms and utility rooms. It can be fixed to a wall or ceiling under a porch, in a garage or beside an external door.

How does the PIR sensor work?

The built-in PIR detects movement and switches the light on automatically, then off again after the area is clear. This suits entrances, hallways and outdoor approaches where hands-free, on-demand light is helpful. There is no separate bulb to fit, as the LED is integrated.

How do I clean the fitting?

Switch off the supply and wipe the polycarbonate diffuser and white housing with a soft, slightly damp cloth, then dry it. Avoid abrasive pads or solvent cleaners, which can mark the surface. Take care not to obstruct the PIR lens so detection stays reliable.