Description
The Zephyra is a round recessed ground light with a 6W integrated LED delivering 3000K warm-white output through an adjustable tilt module set into a 175mm diameter grey stainless steel bezel. The LED module tilts +/-30° from vertical, allowing the beam to be directed at pathways, planting, walls or architectural features rather than being locked at a fixed upward angle.
Designed for driveways, patios, garden borders and exterior path lighting, the Zephyra requires a 104mm excavation depth and sits flush with ground level once installed. The IP67 rating protects the internal LED and driver from dust ingress and water immersion up to 1m depth for 30 minutes, making it suitable for areas subject to heavy rain, jet-washing or occasional flooding. The 1380mm cable allows flexibility in positioning the transformer or junction box away from the installation point.
The grey stainless steel bezel provides a low-contrast finish that blends into paving, gravel or resin-bound surfaces during daylight without creating a visual hotspot. The bezel is fixed with two countersunk screws that sit below the surface profile, preventing trip hazards and allowing lawnmowers or wheeled equipment to pass over the fitting without catching. The 6W LED runs at 3000K colour temperature, which matches traditional halogen exterior lighting and pairs well with brick, stone and warm-toned timber cladding.
Specification
| Length (mm) |
175 |
| Projection (mm) |
195 |
| Height (mm) |
104 |
| Cable Length (mm) |
1380 |
| Dimmable |
No |
| Number Of Bulbs |
1 |
| Bulb Type |
LED |
| Colour Temperature |
3000K |
| IP Rating |
IP67 |
| Warranty |
5 Years |
Frequently Asked
What does IP67 mean for outdoor use?
IP67 means the fitting is fully dust-tight and can withstand water immersion up to 1m depth for 30 minutes. In practical terms, the Zephyra can handle heavy rain, jet-washing, standing water and occasional flooding without water ingress damaging the LED or driver.
Can the beam angle be adjusted after installation?
Yes. The LED module tilts +/-30° from vertical and can be re-aimed after installation without excavating the fitting. This allows you to redirect the beam as planting grows or as you reconfigure garden features.
What excavation depth is required?
The fitting requires a 104mm excavation depth to sit flush with the ground surface. You will also need to run the 1380mm cable to a suitable transformer or junction box positioned away from the installation point.
Is the bezel vehicle-rated?
The specification does not state a vehicle load rating. The fitting is designed for pedestrian traffic, patios and garden borders. If you need ground lights rated for vehicle traffic or driveways, contact us to confirm suitability before installation.