Varso LED Ø330 24W Round Bulkhead Warm White - White

The Varso LED is a round bulkhead fitting that draws 24W and delivers 2160 lumens of warm white 3000K light, spread evenly through a wide 120 degree beam. Running on 220-240V mains, it carries an integrated LED rather than a replaceable bulb, so there is nothing to swap out over its rated life. American buyers will recognise this format as an outdoor wall sconce or wall pack, the surface fitting that washes a doorway or boundary wall with a soft, glare-free glow rather than a tight spot.

Measuring Ø327 by 49 mm, the Varso sits close to the surface and suits porches, carports, covered entrances and sheltered passageways, as well as bathroom areas where a flush, splash-rated fitting is needed. Its warm 3000K tone keeps entrance halls, stairwells and utility corners welcoming rather than clinical. The broad 120 degree spread lights the immediate area around the fitting evenly, marking a doorway, threshold or short run of wall without harsh pooling, which makes it a practical choice for repeated use along a covered walkway.

Built from white plastic with a round diffuser, the Varso is rated IP54, so it shrugs off splashes and damp in sheltered locations though it should be kept clear of direct water jets and fully exposed positions. The fitting runs straight from mains voltage with no separate driver to specify, and it is not dimmable. The clean white finish keeps it discreet against most ceilings and walls. This range also includes alternative wattage and size options for matching a scheme across several entrances.

Can the Varso be used outdoors?

Yes, within sheltered spots. Its IP54 rating handles splashes and damp under a porch, carport or covered entrance, but keep it out of fully exposed positions and away from direct rain or water jets. For bathrooms it suits splash zones rather than areas of direct spray.

Does it come with a bulb?

No separate bulb is needed. The Varso uses an integrated LED rated for around 20,000 hours, so there is nothing to fit or replace. When the LED reaches the end of its life the whole fitting is changed.

Where is this fitting typically used?

It works well on entrance walls, in porches and carports, along covered walkways, and in stairwells, hallways and utility spaces. The warm 3000K tone and wide 120 degree spread give an even, welcoming light across the area immediately around the fitting.

How do I clean the diffuser?

Switch off the power and let the fitting cool, then wipe the round diffuser with a soft, slightly damp cloth. Avoid abrasive cleaners or solvents on the white plastic, as these can dull the surface. A regular wipe keeps the light output bright and even.