TEDI GU10 LED Spotlight Bulb 9W 65W-eq 900lm 120° - Daylight

The TEDI is a GU10 spotlight bulb that puts out 900 lumens from just 9W, standing in for an old 65W halogen while drawing a fraction of the power. The cap is a GU10 twist-lock that runs straight off the mains at 220 to 240V AC, so there is no separate transformer to think about, unlike the low-voltage GU5.3 MR16 type. American shoppers will recognise this PAR16 reflector format as a standard mains spot bulb. Light comes out at 6000K, a clean daylight tone with a slightly cool, crisp feel, spread across a wide 120 degree beam that washes a broad area rather than throwing a tight pencil spot.

The wide 120 degree spread makes the TEDI a sensible choice for general directional lighting where you want even fill rather than a sharp highlight, so it suits recessed ceiling fittings, track heads and spotlight bars in kitchens, hallways, home offices and retail or display settings. The daylight colour reads as bright and neutral, which helps with task areas, work surfaces and anywhere you want true colour. Because the beam is broad, fewer fittings are needed to cover a run of ceiling than a narrow-beam bulb would manage. This is an indoor bulb only, so keep it clear of bathrooms, porches and any damp or outdoor position.

The body is a white PAR16 spot measuring 50mm across and 55mm long, weighing 56g, which drops into any standard GU10 holder. Colour rendering sits at Ra 80, giving accurate enough colour for everyday rooms and display use. The bulb is non-dimmable, so pair it with a plain on/off switch rather than a dimmer circuit. Rated life is 20,000 hours and efficiency is 100 lm/W, with an IP20 rating that confirms dry indoor use. The TEDI is part of a wider GU10 range from Kanlux that includes other wattages and beam options if you need to match output across a scheme.

Product Specification Sheet

Range Datasheet

Which fitting do I need for this bulb?

The TEDI uses a GU10 cap, the standard twist-lock mains spotlight fitting. You push it in and give it a quarter turn to lock. It runs directly off the mains at 220 to 240V AC, so no transformer or driver is required, unlike the low-voltage GU5.3 MR16 type.

What old bulb wattage does it replace?

The TEDI draws just 9W but produces 900 lumens, which matches the brightness of an old 65W halogen GU10. The 9W figure is the actual power it uses; the 65W is only the equivalent for comparison, so you get the same light for far less energy.

Can it be dimmed?

No, this is a non-dimmable bulb. It should be used on a standard on/off switch rather than a dimmer circuit. Fitting it to a dimmer may cause flicker, buzzing or a shortened lifespan.

What colour and beam does it give?

The light is 6000K daylight, a clean and crisp cool-white tone that suits task areas and display lighting. The beam angle is a wide 120 degrees, so it spreads light broadly and evenly rather than throwing a tight, focused spot.