Description
Small enough to go almost unnoticed on a wall until dusk, this is a compact outdoor light with an anthracite body and a clear cover over the lens. The LED sits inside and is not a changeable lamp: it draws 3W and gives 270 lumens of warm white light, which reads as a soft pool close to the wall rather than a broad wash across it. Output is fixed rather than dimmable, and switching happens on the circuit rather than at the fitting.
It suits the places where light needs to mark a route rather than fill a space: either side of a front door, along a path through a back garden, up a flight of outside steps, or beside a garage door. The small footprint helps on narrow walls and in porches where a lantern would crowd the space. We reach for it in pairs, or in a run along a boundary wall, because several low output points give a calmer result outdoors than one bright one. Sheltered exterior positions suit it best, as it is sealed against dust and splashing rain.
The anthracite finish is a flat dark grey that disappears against brick, render and stone, and the clear cover keeps the light source visible without adding colour to it. Grit, salt air and cobwebs are what dull an outdoor fitting, so give the cover an occasional wipe with a damp cloth and dry it off, with the power off first. Nothing else is needed. It carries a three year warranty. We also stock the same light in sand white, which is the one to choose on painted or light render, and the two mix happily on the same house if the front and back walls differ.
Specification
| Colour |
Anthracite |
| Ceiling Mountable |
Yes |
| Weight |
0.21KG |
| Length |
99mm |
| Height |
88mm |
| Projection |
33mm |
| Materials Used |
Aluminium Die-Casting Body, Glass Diffuser |
| Energy Class |
G |
| Max Energy Class |
G |
| Min Energy Class |
G |
| Lamp |
1 x 3W integrated LED (no lamps to fit) |
| Lamp Cap |
Integral LED |
| Recommended Lamp |
Integral LED |
| Colour Temperature |
3000K Warm White (±5%) |
| System Flux |
270lm (±5%) |
| Light Distribution |
Single Direction |
| Protection Class |
Class 1 - Earth Connection Required |
| Total Power Consumption |
4W (±5%) |
| Input Voltage |
220-240V~50/60Hz |
| Switch |
Not Switched |
| Dimmable |
No |
| IP Rating |
IP54 |
| Warranty |
3yrs |
| UKCA/CE |
Yes |
| Shade Colour |
Clear |
| Pieces Included |
1 |
| Installation |
Requires Installation By Qualified Electrician |
| Product Care |
(1) Ensure light is not illuminated when cleaning. (2) Remove dirt with a damp cloth, do not use any detergents, do not clean with any pressurised water. |
| Country of Origin |
China |
Frequently Asked
How bright is it, and what colour is the light?
It produces 270 lumens at 3000K, a warm white close to the tone of a traditional filament lamp. That is accent brightness for marking doors, steps and paths rather than lighting a whole garden.
Can the LED be replaced when it eventually fails?
No. The LED is integrated into the fitting, so there is no separate lamp to buy or change. When it reaches the end of its life the whole light is replaced.
How much wall does it take up?
Very little: 99mm across, 88mm tall, and it stands just 33mm off the wall, so it stays clear of doorways, gates and narrow passages.
Is it dimmable or fitted with its own switch?
It is neither dimmable nor switched at the fitting. Control comes from the switch, timer or sensor on the circuit feeding it.
Will it cope with a fully exposed wall?
Its IP54 rating covers dust and splashed water, which suits porches, side walls and other reasonably sheltered spots better than a position taking the full force of driven rain.
Which finishes are available?
This one is anthracite with a clear cover, and the same light is also made in sand white.