Description
The IPER LED is a round LED bulkhead drawing 19W and delivering 2280 lumens of 4000K neutral white light across a wide 120 degree spread. American buyers will recognise this format as an outdoor wall pack or wall sconce, a sealed surface fitting that washes light evenly across the surface it is fixed to rather than throwing a tight beam. Its efficiency of 120 lm/W and 50,000 hour rated life make it a practical fit-and-forget choice, and the integrated LED runs straight from a 220-240V AC mains supply with no separate driver to specify.
Both ceiling and wall mounting are supported, so the IPER LED suits entrances, porches, stairwells, corridors, car parks and external walls where a robust, low-maintenance fitting is needed. The 120 degree beam spreads broadly to mark a doorway or wash a length of wall, giving useful surround light around an entry point rather than a focused spot, so it works well as orientation and security lighting near doors, gates and walkways. At roughly 200mm across and only 55mm deep it sits flush and unobtrusive against the surface.
The body is moulded plastic in a clean white finish, rated IP65 for full weatherproofing against rain and wash-down and IK10 for strong impact resistance, which suits exposed outdoor positions and busy communal areas alike. The LED is built in and not user-replaceable, and the fitting is non-dimmable, running at a steady neutral white output. Surface mounting to wall or ceiling is straightforward via the sealed gear tray. The IPER LED range includes further wattage options for matching a run of entrances or a longer corridor.
Specification
| Power |
19W |
| Voltage |
220-240 AC |
| Luminous flux |
2280 lm |
| Efficiency |
120 lm/W |
| Colour temperature |
4000K |
| Colour rendering (CRI) |
Ra 80 |
| Beam angle |
120° |
| IP rating |
IP65 |
| IK rating |
IK10 |
| Dimmable |
No |
| Mounting |
Ceiling Mounted, Wall Mounted |
| Lifespan |
50,000 hours |
| Shape |
Round |
| Dimensions |
Ø200 × 55 mm |
| Weight |
440 g |
| Material |
Plastic |
| Finish |
White |
Downloads
Frequently Asked
Can the IPER LED be used outdoors?
Yes. It carries an IP65 rating, which means it is fully weatherproof against rain and direct water spray, so it is suitable for exposed external walls, porches and open car parks. The IK10 rating also gives it strong resistance to knocks and impact.
Is a bulb included or does it need one?
No separate bulb is needed. The LED is integrated into the fitting and is not user-replaceable, delivering 2280 lumens of 4000K neutral white light. The whole unit is rated for around 50,000 hours of use.
Where is this bulkhead typically used?
It is well suited to entrances, porches, stairwells, corridors, communal areas and external walls. Both wall and ceiling mounting are supported, and the wide 120 degree spread makes it a good choice for orientation and security lighting around doors and walkways.
How should the fitting be cleaned and maintained?
Wipe the white diffuser and body with a soft, damp cloth and a mild detergent, then dry it off; avoid abrasive cleaners that could scratch the plastic. Make sure the mains supply is switched off first, and check the IP65 seal is intact when refitting for outdoor positions.