Iper LED 10W Ø350 Round PIR Bulkhead IP65 - White

The Iper LED is a round bulkhead light with a built-in PIR motion sensor, drawing 10W to deliver 1200 lumens at a neutral 4000K white. The 120 degree beam spreads light broadly across the surface below, while the integrated sensor switches the fitting on automatically when movement is detected and off again after the area clears. Measuring 350mm across, it is the kind of fitting that American buyers would recognise as an outdoor wall pack or wall sconce, though its low round profile and ceiling option make it equally at home overhead.

Outdoors it works well by porches, side passages, garage entrances and stairwells where hands-free, sensor-triggered light is wanted, and indoors it suits utility rooms, communal corridors and outbuildings. Because the PIR drives the output on and off rather than holding a steady ambient level, coverage is best judged by the area the sensor and beam can usefully light on approach rather than by a room lux figure. The 1200 lumen output and wide 120 degree spread give clear, even illumination across an entrance or a short run of path, with the sensor reach setting how early the light responds as you draw near.

Built from white plastic with a round one-piece body, the fitting carries an IP65 rating for full weatherproofing in exposed and wet locations and an IK10 impact rating for knock resistance. The LED runs direct from a 220 to 240V AC supply with the driver gear housed inside, so there is nothing separate to mount or wire, and it fixes either to a wall or to a ceiling. The light is not dimmable and is rated for 50,000 hours of service. The wider Iper range includes matching bulkheads in plain and sensor versions for consistent fittings across a site.

Can this bulkhead be used outdoors?

Yes. It carries an IP65 rating, which means it is fully weatherproof and suitable for exposed outdoor and wet locations such as porches, entrances and passageways. The IK10 rating also gives it strong resistance to impact and knocks.

How does the PIR sensor work?

The built-in PIR sensor detects movement nearby and switches the light on automatically, then turns it off again once the area is clear. This makes it ideal for entrances and walkways where hands-free, on-demand light is useful. Timing and sensitivity are set on the fitting itself.

Where is this fitting typically used?

It suits porches, garage entrances, side passages and stairwells outdoors, and utility rooms, corridors and outbuildings indoors. The round low-profile body works on both walls and ceilings, so it can sit overhead or beside a doorway depending on the location.

How should the fitting be cleaned?

Wipe the white plastic body and diffuser with a soft damp cloth and a mild detergent, avoiding abrasive cleaners that could scratch the surface. Always switch the supply off and let the fitting cool first. Keeping the diffuser clear helps maintain the full 1200 lumen output.