Description
The Iper LED is a square LED bulkhead drawing 10W to deliver 1200 lumens of neutral white 4000K light, with an efficiency of 120 lm/W. Its wide 120 degree spread pushes an even wash across the surface it sits on rather than a tight beam, so wall or doorway areas are lit without harsh pools or shadows. Mains-wired at 220-240V AC, it suits both wall and ceiling positions. In the US this style of fitting is often sold as an outdoor wall sconce or wall pack, the kind used to mark entrances and passageways.
Around the home and on light commercial sites the Iper works well by front and back doors, along covered walkways, in porches, stairwells and over garage and utility entrances. The neutral 4000K tone keeps boundaries and steps clearly defined for safety, while the 120 degree beam means a single unit covers a doorway or short stretch of path comfortably; spacing several along a longer run gives continuous coverage with no dark gaps. At 200 x 200 x 55 mm it stays close to the surface, so it reads as a discreet marker light rather than a bulky fitting on a wall or soffit.
The body is moulded plastic in a white finish, rated IP65 so it copes with exposed outdoor and fully wet locations, and IK10 for strong resistance to knocks and tampering in busier areas. The integrated LED array is rated for 50,000 hours, removing any bulb changes over its life, and it runs direct from mains supply. This model is not dimmable, giving full, steady output whenever it is switched on. The Iper range includes further bulkhead options if you need to match fittings across a site.
Specification
| Power |
10W |
| Voltage |
220-240 AC |
| Luminous flux |
1200 lm |
| Efficiency |
120 lm/W |
| Colour temperature |
4000K |
| Colour rendering (CRI) |
Ra 80 |
| Beam angle |
120° |
| IP rating |
IP65 |
| IK rating |
IK10 |
| Dimmable |
No |
| Mounting |
Ceiling Mounted, Wall Mounted |
| Lifespan |
50,000 hours |
| Shape |
Square |
| Dimensions |
200 × 200 × 55 mm |
| Weight |
508 g |
| Material |
Plastic |
| Finish |
White |
Downloads
Frequently Asked
Can the Iper LED be used outdoors?
Yes. It carries an IP65 rating, which means it is weatherproof and suitable for fully exposed outdoor and wet locations such as external walls, porches and covered walkways. Its IK10 rating also gives it strong protection against impact and tampering.
Does it take a replaceable bulb?
No. The Iper uses an integrated LED array rather than a separate lamp, so there is nothing to replace. The array is rated for 50,000 hours, which equates to many years of typical outdoor use before any noticeable drop in output.
Where is this bulkhead typically fitted?
It suits entrances, porches, stairwells, covered walkways and garage or utility doorways. The wide 120 degree beam and neutral 4000K light keep steps and boundaries clearly visible, and it can be mounted on either a wall or a ceiling at 220-240V AC mains supply.
How should the fitting be cleaned?
Switch off the supply and let it cool, then wipe the white surface with a soft, damp cloth to remove dust, salt or grime that can build up outdoors. Avoid abrasive pads or solvents, which can mar the plastic body, and make sure it is dry before switching back on.