Iper 35W Round LED Bulkhead IP65 PIR Ø350 - White

The Iper is a round LED bulkhead drawing 35W and putting out 4200 lumens at a neutral 4000K white, with a wide 120 degree spread that washes light evenly across a wall or soffit. A built-in PIR sensor switches the fitting on when movement is detected, so it runs only when needed. North American buyers will recognise this format as an outdoor wall pack or wall-mounted security light, the same role filled here by a compact 350mm disc. With its integrated LED array there is no separate bulb to replace over the rated life of the fitting.

Sitting flush against a wall or ceiling, the Iper suits entrances, porches, stairwells, garage sides, car ports and the exterior of utility buildings where a movement-triggered light improves safety after dark. The 120 degree beam and PIR pairing make it well placed above a doorway or along an access route, marking the approach and triggering as someone arrives. Because this is a sensor-driven security and amenity fitting rather than ambient room lighting, think of its 4200 lumens in terms of throw and coverage of the immediate area it overlooks, not a measured floor area. Mount it at a height where the sensor can sweep the path or doorway you want covered.

Built from white plastic with a sealed, round body, the Iper carries an IP65 rating for full weatherproofing in exposed outdoor and wet locations, plus an IK10 rating for strong impact resistance. It runs directly from 220-240V AC mains and is surface mounted to a wall or ceiling, measuring 350mm in diameter and 55mm deep at 1.10kg. The fitting is not dimmable, which suits its switched security role. The white finish keeps it discreet against most exterior walls.

Is the Iper suitable for outdoor use?

Yes. It carries an IP65 rating, which means it is fully weatherproof and rated for exposed outdoor and wet locations. It also has an IK10 impact rating, so it stands up well to knocks and rough conditions.

How does the built-in PIR sensor work?

The fitting has an integrated PIR sensor that detects movement and switches the light on automatically, then off again after the area is clear. This makes it well suited to entrances, paths and garage sides where you want light only when someone approaches.

Does it take a replaceable bulb?

No. The Iper uses an integrated LED array rated for 50,000 hours, so there is no separate bulb to fit or change. The whole unit is designed to run maintenance-free across its rated life.

How should I clean it?

Wipe the white plastic body and lens with a soft, damp cloth to remove dirt and cobwebs, taking care to keep the sensor window clear so detection is not affected. Avoid abrasive cleaners or solvents, which can mark the surface. Make sure the power is off before cleaning.