Description
Squared off and compact, this one throws a wash of light up the wall above it and again down towards the ground, so you get soft grazing light rather than a single flat beam. The body is a neat 10cm cube in sand white, a chalky off white that sits quietly against render or brick during the day. Clear shades and a warm 3000K output give a mellow, faintly golden light. The LED is built in and runs at a fixed level rather than on a dimmer.
We would use it flanking a front door, or run a line of them along a garden wall where the light on the surface matters as much as the light on the path. It works well over a porch, down a side return, on a balcony or along the walk between house and garage, and it is one we reach for when a lantern would look too fussy or stand too far off the wall. As it has no switch on the body, it is meant to be controlled from indoors, or by a timer or photocell.
The casing is sealed well enough to shrug off dust and splashing water, so rain and the odd sweep of the hose are no trouble, and the sand white finish keeps its softness rather than glaring in sunlight. Every few months, with the power off, wipe the housing and the clear shades with a damp cloth to lift pollen, salt and cobwebs, then let them dry fully before you put the light back on. Nothing harsher than mild soapy water is needed. It carries a three year warranty. We also stock the same fitting in anthracite, which is the one to choose if you would rather it read as a dark line against pale walls. The LED is integrated, so there are no lamps to buy or replace.
Specification
| Colour |
Sand White |
| Ceiling Mountable |
Yes |
| Weight |
0.63KG |
| Length |
100mm |
| Width |
100mm |
| Projection |
100mm |
| Materials Used |
Aluminium Die-Casting Body, Glass Diffuser |
| Energy Class |
G |
| Max Energy Class |
G |
| Min Energy Class |
G |
| Lamp |
2 x 3W integrated LED (no lamps to fit) |
| Lamp Cap |
Integral LED |
| Recommended Lamp |
Integral LED |
| Colour Temperature |
3000K Warm White (±5%) |
| System Flux |
410lm (±5%) |
| Light Distribution |
Multiple Directions |
| Protection Class |
Class 1 - Earth Connection Required |
| Total Power Consumption |
7W (±5%) |
| Input Voltage |
220-240V~50/60Hz |
| Switch |
Not Switched |
| Dimmable |
No |
| IP Rating |
IP54 |
| Warranty |
3yrs |
| UKCA/CE |
Yes |
| Shade Colour |
Clear |
| Pieces Included |
1 |
| Installation |
Requires Installation By Qualified Electrician |
| Product Care |
(1) Ensure light is not illuminated when cleaning. (2) Remove dirt with a damp cloth, do not use any detergents, do not clean with any pressurised water. |
| Country of Origin |
China |
Frequently Asked
How much light does it give out?
It produces around 410 lumens in total from 6W, split between the upward and downward beams. That is enough to mark a doorway or wall pleasantly rather than flood a whole driveway.
Is it suitable for an exposed wall?
It is rated IP54, so it copes with dust and splashed water from any direction. A spot with some shelter, such as under an eaves overhang, will always keep it looking its best for longer.
Can I dim it?
No, it is non-dimmable and gives a fixed 3000K warm white output. Fitting it on a dimmer circuit is not recommended.
How far does it stand off the wall?
Projection is 100mm, matching its 100mm height and width, so it stays tight to the wall and out of the way in a narrow passage.
What happens when the LED reaches the end of its life?
The LED is integral to the fitting, so there is no lamp to change. At that point the whole unit is replaced.
Does it need an earth?
Yes, it is a Class 1 fitting and requires an earth connection.