Description
Light leaves this one in both directions, up the wall and down it, through frosted diffusers at each end of a small anthracite body. The output is warm white at 3000K, which keeps brickwork and render looking soft rather than blue, and a total of 452 lumens is enough to wash a door surround or mark a boundary wall without glare. The form is plain and shallow, with squared ends and no visible clutter. We reach for it where a lantern would look too fussy.
Outdoors it suits front doors, porches, side passages and garden walls, and a pair either side of an entrance gives an even, balanced wash. Sealed against dust and splashing water, it copes with an exposed wall as well as a sheltered one. There is no switch on the fitting itself, so it runs from an indoor switch, a timer or a photocell as you prefer, and the light is fixed rather than dimmable. Warm white at this level is kind to a house at night: bright enough to read a step by, quiet enough not to bother a bedroom window above.
The housing is finished in anthracite, a grey that sits quietly against slate, dark render and modern joinery, and the frosted covers spread the light evenly rather than showing hot spots. The LEDs are integrated, so there is nothing to replace. Care outdoors comes down to keeping the diffusers clear: wipe them with a damp cloth when you do the windows, and lift away any leaves or cobwebs that gather along the top edge. It carries a three year warranty. We stock the same light in sand white, and a smaller version in either finish if the proportions suit the wall better.
Specification
| Colour |
Anthracite |
| Ceiling Mountable |
Yes |
| Weight |
0.55KG |
| Length |
175mm |
| Height |
90mm |
| Projection |
30mm |
| Materials Used |
Aluminium Die-Casting Body, Frosted Glass Diffuser |
| Energy Class |
G |
| Max Energy Class |
G |
| Min Energy Class |
G |
| Lamp |
2 x 6W integrated LED (no lamps to fit) |
| Lamp Cap |
Integral LED |
| Recommended Lamp |
Integral LED |
| Colour Temperature |
3000K Warm White (±5%) |
| Number of Switching Cycles |
30000 |
| System Flux |
452lm (±5%) |
| Light Distribution |
Multiple Directions |
| Protection Class |
Class 1 - Earth Connection Required |
| Total Power Consumption |
13.5W (±5%) |
| Input Voltage |
220-240V~50/60Hz |
| Switch |
Not Switched |
| Dimmable |
No |
| IP Rating |
IP54 |
| Warranty |
3yrs |
| UKCA/CE |
Yes |
| Shade Colour |
Frosted |
| Pieces Included |
1 |
| Installation |
Requires Installation By Qualified Electrician |
| Product Care |
(1) Ensure light is not illuminated when cleaning. (2) Remove dirt with a damp cloth, do not use any detergents, do not clean with any pressurised water. |
| Country of Origin |
China |
Frequently Asked
How big is it on the wall?
It measures 175mm long by 90mm high, and sits close to the wall with a projection of just 30mm.
Can the LEDs be changed?
No. The light source is integrated, running as 2 x 6W to give 452lm in total, so there are no lamps to buy or swap.
How warm is the light?
It is 3000K warm white, a soft yellow-white that flatters brick, stone and painted render at night.
Will it work with a dimmer?
No, it is non-dimmable. It is best run from a standard switch, a timer or a photocell.
How exposed a position can it take?
It is IP54 rated, protecting it against dust and splashing water from any direction, which covers most house walls, porches and garden walls.
How should it be cleaned?
Wipe the anthracite housing and the frosted diffusers with a damp cloth and a little mild detergent, then dry off. Avoid solvents and abrasive creams, which can dull the finish.