Description
The Berg is a compact in-ground light that recesses flush into paving, decking or a driveway, taking a GU10 PAR16 LED lamp up to 10W on a 220-240V AC supply. It sits level with the surface so it can be walked or driven over rather than standing proud, and casts its beam upward to graze whatever sits above it. Buyers in the US will know this format as a well light or in-grade fixture, the buried uplighter that washes light up a wall or tree trunk. At 110 x 110 x 145 mm with a square steel face, it keeps a small footprint at ground level while the body buries into the recess below.
The fitting suits front paths, patios, decking runs and driveways, where its flush walk-over and drive-over installation lets it sit directly in the route of foot and vehicle traffic. Because it throws light upward rather than spreading an ambient wash, place it close to a wall, planted bed, post or tree to pick out texture and shape after dark. A line of them set into a driveway edge or deck perimeter reads as a run of grazing uplight rather than general area lighting, so think in terms of what each unit is aimed at rather than a floor area covered. The 145 mm body depth sets the recess you need to allow for in paving or timber, along with drainage below.
Construction is steel with a stainless steel finish, rated IP67 for full weatherproofing in exposed and wet ground positions, and IK08 for impact resistance under traffic. The GU10 PAR16 LED lamp is replaceable through the fitting once installed. Mounting is on or into the ground, recessed flush so the face finishes level with the surface around it. The Berg range covers further ground and decking fittings in matching steel if you want a consistent look across a scheme.
Specification
| Power |
max 10W |
| Voltage |
220-240 AC |
| IP rating |
IP67 |
| IK rating |
IK08 |
| Mounting |
Mounted On The Ground, In-Ground |
| Cap / base |
GU10 |
| Light source |
PAR16 LED |
| Shape |
Square |
| Dimensions |
110 × 110 × 145 mm |
| Weight |
842 g |
| Material |
Steel |
| Finish |
Stainless Steel |
Downloads
Frequently Asked
Can it be walked or driven over?
Yes. The Berg recesses flush into the ground and is rated IK08 for impact, so it can be walked over and is built to take vehicle traffic when set into a driveway. Make sure the surrounding surface is firm and the recess is fully supported underneath.
Is it suitable for wet outdoor locations?
Yes. It carries an IP67 rating, which means it is fully weatherproof and protected against temporary immersion, so it copes with exposed positions, rain and standing water at ground level. Allow for drainage in the recess so water does not pool around the body.
Does it take a replaceable bulb?
It uses a GU10 PAR16 LED lamp rated up to 10W, running directly from a 220-240V AC mains supply. The lamp is a standard GU10 fitting, so it can be swapped if it fails rather than replacing the whole unit.
How deep does the recess need to be?
The fitting measures 110 x 110 x 145 mm, so allow at least 145 mm of depth in the paving or decking for the body, plus space below for drainage. The square steel face finishes flush with the surface once installed.