AZ-10A IP65 LED Bulkhead Wall Light - White

The AZ-10A is a compact LED bulkhead wall light that throws a steady, even wash across the surface it is mounted to. Wall mounted and running on a 220-240V AC supply, it gives the clean, low-profile light output that buyers searching for an outdoor bulkhead or led bulkhead expect, and in US terms it covers the same job as a small outdoor wall pack. At 48 x 30 x 63 mm it is one of the smaller fittings in this format, so the light it casts is close and controlled rather than broad, marking a doorway, step or wall panel without spilling far.

Because it carries an IP65 rating, this fitting suits fully exposed outdoor positions as well as sheltered ones: entrance walls, porches, side passages, garden boundaries and damp utility spots all work. The throw here is short and directional rather than room-filling, so think of it as marking and guiding light around a threshold or along a wall rather than lighting a whole space. Mounted at head height beside a door or lower down to graze a path edge, it gives presence and orientation after dark. Spaced along a run of wall, several units build a consistent line of light across a façade or boundary.

Construction is built for outdoor duty, with the IP65 sealing keeping out rain and water jets so it holds up in wet and exposed locations. It mounts flat to the wall through its fixing points and weighs just 100 g, which keeps installation straightforward on render, brick or timber cladding. The integrated LED runs direct from the mains AC supply, so there is no separate lamp to replace. The white finish stays neutral against most wall colours and resists the weathering you get on an outdoor fitting.

Can this bulkhead be used outdoors?

Yes. The AZ-10A is rated IP65, so it is sealed against rain and water jets and suits fully exposed outdoor walls as well as sheltered porches and passageways. It is equally at home in damp utility areas indoors.

Does it take a separate bulb?

No. This is an integrated LED fitting, so the light source is built in and runs direct from the 220-240V AC mains supply. There is no E27 or other lamp to buy or replace over its life.

Where is this fitting typically used?

It works well beside doors and entrances, along garden walls and boundaries, on side passages and porches, and at step or path edges. The compact 48 x 30 x 63 mm body keeps the throw close and controlled, making it a good marking and orientation light.

How do I keep it clean?

Wipe the white housing with a soft, damp cloth to clear off dust, cobwebs and weathering, then dry it off. Avoid harsh solvents or abrasive pads so the finish and the IP65 seal stay intact. A regular wipe keeps the light output bright on exposed sites.