Description
The Lika is a compact rectangular ceiling spot, a small surface-mounted box in white die-cast aluminium that sends a single directed beam straight down. A recessed LED sits behind a black reflector set into the face, so the source stays out of direct view and the light reads as a clean pool below rather than a visible lamp. Off, it holds a low, tidy block against the ceiling at just 135mm long.
The LED is built in and gives 360 lumens through a narrow 40-degree beam, a tight pool for marking out a picture, a worktop edge or a reading spot rather than lighting a whole room. Colour is a warm 3000K with a colour rendering above 90, so tones stay true under it, and the black internal reflector holds glare low at UGR below 16. Several in a row make a measured line of accents across a ceiling.
The body is painted die-cast aluminium in white with a black polycarbonate reflector, rated IP20 for dry indoor rooms and built to Class II. The driver is in-built and included, and the fitting runs on plain on-off switching as supplied, with an optional DALI or push driver available if dimming is needed. We supply it complete, with the LED built in and nothing to fit.
Specification
| Number of lights |
1 |
| Light source |
Integrated LED, 6W total (360lm beam / 250lm useful, 3000K, CRI>90, UGR<16, 50,000h) |
| Colour temperature |
3000K (warm white) |
| Beam angle |
40 degrees (downward) |
| Width |
135mm |
| Height / Drop |
80mm (surface projection from ceiling) |
| Depth |
35mm |
| IP rating |
IP20 (indoor) |
| Dimmable |
No (on-off as supplied; optional DALI/push driver available) |
| Frame / Structure finish |
White die-cast aluminium |
| Materials |
painted die-cast aluminium body and black polycarbonate reflector |
Downloads
Datasheet
Assembly Instructions
3D Model
Frequently Asked
What kind of light does it cast?
A focused warm downlight. The built-in LED sits behind a black reflector and throws 360 lumens through a tight 40-degree beam at 3000K, picking out a spot rather than lighting a room.
Is there a bulb to fit?
No. The LED is built into the body with the driver included, rated for about 50,000 hours, so the spot arrives ready to wire with no lamp to add or replace in normal use.
Can it be dimmed?
Not as supplied. It runs on plain on-off switching, so the warm output holds at one level. An optional DALI or push driver from the same range can be fitted if dimming is required, and we can advise on this before you order.
How big is it and where does it suit?
The body is 135mm long, 80mm high and 35mm deep, mounted flat to the ceiling. The tight beam suits a picture, a worktop edge or a reading spot, singly or repeated in a run.