Tribis II C/M GU10 Recessed Downlight - Matte Chrome

The Tribis II C/M is a round recessed downlight built for a GU10 lamp, taking a PAR16 LED of up to 10W from a standard 220 to 240V AC mains supply. It drops into the ceiling as a fixed trim, so the visible ring sits flush with the surface while the lamp throws light downward. Wired for the popular GU10 cap that retailers in the US would recognise as the same twist-and-lock spotlight base, it runs at a warm 3000K with a colour rendering of Ra 80, giving a soft, homely tone that suits living spaces rather than cool task areas.

Recessed can lights like this are at home across hallways, landings, bedrooms and living rooms, where several are usually run in a line or grid to spread even light over the floor below. As a single GU10 fitting it works as a building block, so the number you need depends on ceiling height and how closely you space them rather than on one fixed coverage figure. At standard domestic ceiling heights a spotlight of this size typically lights a focused pool beneath it, so plan a regular layout for general room coverage. It is an indoor fitting at IP20, so keep it to dry rooms and clear of bathrooms, porches and any damp or exposed positions.

The body is steel with a matte chrome finish, giving a low-key recessed ring that reads as a clean circle once installed. It measures just 82mm across and 22mm deep, weighing 404g, and uses a GU10 lamp holder so the light source can be swapped without disturbing the frame. Mounting is recessed into the ceiling through a cut-out, and the lamp itself is the replaceable part rather than an integrated module. The Tribis range includes matching fittings to keep a run of downlights consistent across a room.

What size cut-out does this downlight need?

The fitting itself is 82mm in diameter, so it drops into a ceiling cut-out sized to suit that frame, which is the hole the trim sits in rather than the visible outer ring. Always check the recess depth of around 22mm against your ceiling void before cutting. The GU10 lamp clips into the holder once the frame is fixed in place.

Is the GU10 lamp included, and is it dimmable?

The fitting takes a GU10 PAR16 LED of up to 10W, and dimming depends on the specific lamp you fit and a compatible dimmer switch. Because the lamp is a separate replaceable part, you can choose a dimmable GU10 if you want adjustable brightness. Check both the lamp and the dimmer are rated for one another before installing.

Can this downlight be used in a bathroom?

No. It is rated IP20, which means dry indoor use only, so it is not suitable for bathrooms, shower zones, porches or any damp or exposed location. Use it in living rooms, bedrooms, hallways and similar dry interior spaces.

How do I clean the fitting?

Switch off the power and let the lamp cool, then wipe the matte chrome ring with a soft, dry or slightly damp cloth. Avoid abrasive cleaners or solvents, which can dull the finish over time. A gentle wipe is usually enough to keep the trim looking fresh once it is recessed into the ceiling.