Description
The Tiberi is a round recessed LED downlight running at up to 29.4W, with selectable colour temperature across 3000K, 3500K and 4000K. American buyers shopping for a recessed can light will recognise the format here: a flush ceiling fitting that drops into the structure rather than sitting proud of it. Light output shifts with the chosen tone, reaching 2970 lumens at warm white, 3160 at neutral white and 3260 at the cooler 4000K setting. A wide 90 degree beam spreads light evenly below, and a Ra 90 colour rendering keeps tones true across skin, fabric and finishes.
The wide beam and strong output make this a good fit for kitchens, bathrooms and hallways where even ceiling coverage matters more than a tight spot. At general lighting levels a single fitting covers around 10 to 11 m², so a small room may need only one or two while a larger living space benefits from a planned grid. The IP44 rating means it copes with splash and moisture, so it suits bathroom zones away from direct spray and covered outdoor spots such as a porch or carport soffit. Keep it clear of fully exposed positions, direct water jets and any setting where it could be submerged.
The body is aluminium alloy in a white finish, measuring Ø230 by 39 mm and weighing 392 g. It is designed for recessed mounting in a ceiling or wall, dropping into a prepared aperture for a flush result. The fitting is not dimmable, and the integrated LED is rated for 50,000 hours, so there is no separate bulb to replace over its life. The Tiberi sits within a wider range of Kanlux recessed downlights if you need matching fittings in other sizes or outputs.
Specification
| Power |
max 29.4W |
| Luminous flux |
2970(WW) /3260(WN) /3160(NW) lm |
| Colour temperature |
3000/3500/4000K |
| Colour rendering (CRI) |
Ra 90 |
| Beam angle |
90° |
| IP rating |
IP44/20 |
| Dimmable |
No |
| Mounting |
Recessed Mount In The Ceiling, Recessed Mount In The Wall |
| Lifespan |
50,000 hours |
| Shape |
Round |
| Dimensions |
Ø230 × 39 mm |
| Weight |
392 g |
| Material |
Aluminium Alloy |
| Finish |
White |
Downloads
Frequently Asked
Is the Tiberi dimmable?
No, this version of the Tiberi is not dimmable and should be run on a standard non-dimming circuit. Pairing it with a dimmer switch may cause flicker or shorten the life of the LED. If you need adjustable brightness, choose a fitting rated as dimmable instead.
What cut-out hole size do I need?
The Tiberi has an overall trim diameter of Ø230 mm, which is the visible face once installed. The recessed cut-out, meaning the hole the body drops into, is smaller than the trim and should be taken from the supplied installation sheet before drilling. Always confirm the cut-out figure against the spec document so the trim seats flush against the surface.
Can I use it in a bathroom?
Yes, the IP44 rating makes it suitable for splash-prone areas such as bathroom zones away from direct spray, as well as covered outdoor spots like a porch. It is not rated for fully exposed positions, direct water jets or submersion. Check your local zone requirements before fitting near a bath or shower.
How do I clean the fitting?
Wipe the white face gently with a soft, dry or slightly damp cloth once the fitting is switched off and cool. Avoid abrasive pads or solvent cleaners, which can mark the painted aluminium and the lens. A light wipe every few weeks keeps light output looking even and consistent.