Description
The Tiberi is a round recessed LED downlight running at up to 21W, putting out between 2090 and 2310 lumens depending on the chosen tone. A built-in colour selectable mode steps through 3000K, 3500K and 4000K, so you can move from a warm domestic glow to a crisper neutral white without swapping the fitting. American buyers will know this format as a recessed can light, dropped into the ceiling void to sit flush behind a clean white trim. The 90 degree beam spreads light evenly across the area below rather than throwing a tight pool, and a CRI of Ra 90 keeps skin tones, paint colours and worktops looking true.
Across a ceiling this downlight covers around 7 to 8 m² at general lighting levels, which makes it a sensible spacing reference when laying out a kitchen, hallway or living area. Its IP44 rating adds splash resistance, so it also suits bathroom and en-suite zones away from direct spray as well as a sheltered porch or carport soffit. Keep it clear of fully exposed positions, direct water jets and anything submerged, where a higher rating would be needed. Because the fitting is rated for recessed mounting in both ceiling and wall, it gives some flexibility on where the spread of light is aimed within a room.
Construction is aluminium alloy, which draws heat away from the LED and helps support the quoted 50,000 hour lifespan. The fitting measures Ø185 by 36 mm, weighs only 260 g and recesses into the ceiling or wall behind a round white surround, with the colour temperature set on the unit itself. It is not a dimmable model, so pair it with a standard non-dimmed circuit. The white finish keeps it low-key against a plain or painted ceiling. The Tiberi sits within a wider range of recessed downlights, so matching fittings can be specified across connected rooms.
Specification
| Power |
max 21W |
| Luminous flux |
2090(WW) /2310(WN) /2220(NW) lm |
| Colour temperature |
3000/3500/4000K |
| Colour rendering (CRI) |
Ra 90 |
| Beam angle |
90° |
| IP rating |
IP44/20 |
| Dimmable |
No |
| Mounting |
Recessed Mount In The Ceiling, Recessed Mount In The Wall |
| Lifespan |
50,000 hours |
| Shape |
Round |
| Dimensions |
Ø185 × 36 mm |
| Weight |
260 g |
| Material |
Aluminium Alloy |
| Finish |
White |
Downloads
Frequently Asked
What size cut-out does it need?
The fitting has an overall diameter of Ø185 mm, so allow for that footprint at the surface. Always check the supplied installation sheet for the recommended cut-out hole, which is the smaller aperture the body drops through and is distinct from the visible trim diameter. Cutting to the stated cut-out keeps the trim sitting flush.
How do I change the colour temperature?
The downlight is colour selectable across 3000K, 3500K and 4000K, set on the fitting rather than from the wall switch. Pick warmer 3000K for bedrooms and living spaces, or 4000K for a brighter neutral light in kitchens and bathrooms. The selected tone holds each time the light is switched on.
Can it be used in a bathroom?
Yes, its IP44 rating gives splash resistance suitable for bathroom zones away from direct spray, as well as sheltered spots like a porch or carport soffit. It should not be used in fully exposed outdoor positions, under direct water jets or anywhere it could be submerged. For those locations a higher IP rating is required.
How do I clean it?
Wipe the white trim and lens with a soft, dry or slightly damp cloth once the fitting has cooled and the power is off. Avoid solvents and abrasive pads, which can mark the finish. A light dust now and again keeps the output looking bright.