Rounda Ø120 6W LED Downlight Warm White - Black

The Rounda is a round recessed LED downlight running 6W from a 220-240V AC supply and giving 270 lumens of fixed 3000K warm white light. A wide 110 degree beam angle spreads that output gently across the area below rather than throwing a tight spot, so the light arrives soft and even. American buyers will know this format as a recessed can light, sat flush into the ceiling with only the slim round trim showing. At Ø120 by 20 mm it is a shallow, low-profile fitting, and the integrated LED means there is no separate bulb to replace over its life.

Output at this level suits accent and secondary lighting rather than sole illumination of a large room, covering around 1 m² at general lighting levels, so plan several across a space for full coverage. The warm 3000K tone works well in bathrooms, hallways, ensuites and cloakrooms where a softer glow is wanted, and the IP44 rating means it copes with splashes and humidity in bathroom zones and sheltered, covered outdoor spots such as a porch or carport soffit. Keep it clear of fully exposed positions, direct water jets and any submerged use, as IP44 is splash and moisture resistant rather than weatherproof. For ceilings, set fittings in a regular grid spacing to balance the light evenly.

The body is aluminium alloy in a black finish, helping shed heat and keeping the trim discreet against darker ceilings. It carries a dual IP44/20 rating and a rated lifespan of 15,000 hours, and it mounts recessed into the ceiling through a cut-out, leaving the trim flush. The light is fixed at 3000K warm white and is not dimmable, so pair it with a standard non-dimmed circuit. Colour rendering sits at Ra 80, ample for everyday domestic spaces. Other finishes and sizes are available across the wider Rounda range for matching a scheme.

Is the Rounda downlight dimmable?

No, this Rounda is not a dimmable fitting, so it should be wired to a standard non-dimmed circuit. Using a dimmer switch could cause flicker or shorten its life. If you need adjustable brightness, choose a downlight rated as dimmable instead.

What cut-out hole size does it need?

The fitting itself measures Ø120 mm across the trim, so the ceiling cut-out is slightly smaller to let the trim sit flush over the opening. Always check the supplied installation diagram for the exact cut-out diameter before drilling. The fitting is only 20 mm deep, so it suits shallow ceiling voids.

Can it be used in a bathroom?

Yes, the IP44 rating means it resists splashes and humidity, making it suitable for bathroom zones away from direct water contact. It also works in sheltered outdoor spots like a porch or carport soffit. It is not rated for fully exposed positions, direct water jets or submersion.

How do I clean the downlight?

Switch off the power and let the fitting cool, then wipe the trim with a soft, slightly damp cloth. Avoid harsh solvents or abrasive pads, which can mark the black finish. A regular gentle wipe keeps dust off the lens and maintains light output.