Description
The Post-It is a tall rectangular fitting for an outside wall that casts two soft washes, one rising up the surface and one falling below. It sits almost flush, standing just 15mm proud, so by day it reads as a slim upright bar and after dark it lays a pair of gentle pools against the render or brickwork rather than a hard beam. An integrated source hides behind a clear diffuser at each end, giving an even glow with no glare toward the eye.
This is the coffee version, an 80mm wide plate standing 180mm tall in a deep brown tone that settles against brick, timber cladding or natural stone without drawing the eye. The dual wash suits a front door, a porch, a garden boundary or a run of piers, framing an entrance with symmetry from a single point. Its warm 3000K output keeps masonry and wood true after dark.
The body is solid powder-coated aluminium with a clear polycarbonate diffuser, sealed to IP65 against dust and water jets for exposed outdoor use, and rated insulation class III on a safe 12V supply. An integrated OSRAM LED gives 620 lumens at 3000K with a colour rendering index above 90 and a life of 50,000 hours, so there is nothing to change. It draws 6W and runs from a remote driver, supplied separately and wired back to the mains.
Specification
| Number of lights |
1 |
| Light source |
Integrated LED, 6W total (620lm, 3000K, CRI>90, 50,000h, OSRAM SMD, non-replaceable) |
| Colour temperature |
3000K (warm white) |
| Width |
80mm |
| Height |
180mm |
| Projection |
15mm |
| Emission |
Direct and indirect (up and down wash) |
| IP rating |
IP65 (outdoor, dust and water-jet resistant) |
| Dimmable |
No |
| Driver |
Remote 12V driver required, supplied separately |
| Frame / Structure finish |
Coffee-brown powder-coated aluminium |
| Diffuser / Glass |
Clear polycarbonate diffuser |
| Materials |
Solid powder-coated aluminium body, polycarbonate diffuser |
Downloads
Datasheet
Assembly Instructions
3D Model
Frequently Asked
What kind of light does the Post-It give?
Two soft washes from an integrated LED at a warm 3000K, one thrown up the wall and one down. Clear diffusers spread the output evenly at each end, so it lays a pair of gentle pools against the surface rather than a single sharp beam.
Does it need a bulb?
No. The LED is built into the fitting and cannot be replaced, giving 620 lumens for around 50,000 hours. It runs on a low-voltage 12V supply from a remote driver, which is wired back to the mains and supplied separately from the light.
Can it be used outdoors?
Yes. It is sealed to IP65 against dust and water jets and carries a five-year warranty, so it suits an exposed front door, porch or garden wall. As with any mains outdoor fitting it should be wired by a qualified electrician.
How big is it and where does it suit?
It is a slim upright 80mm wide and 180mm tall, standing just 15mm proud. The dual wash suits a front door, a porch or a garden boundary, framing an entrance or marking a run of piers.