Gavi 10W Recessed Downlight G4 - Chrome

The Gavi is a compact round recessed downlight that drops neatly into the ceiling for a low-profile, built-in finish. It runs on 12V low voltage (12 AC or 12 DC) and takes a G4 capsule lamp rated to a maximum of 10W, so the output you get depends on the lamp you fit. With a slim 73mm round body, it gives a focused pool of light from a small aperture. Buyers in the US will recognise this style as a recessed can light, though in a much smaller low-voltage form than a typical mains fitting.

The Gavi suits indoor rooms where you want discreet, built-in ceiling light without a bulky fitting on show. It works well in clusters across a kitchen, hallway, study or living area, with several fittings spaced along a run to build up an even wash rather than relying on a single point. Because it is a 12V low-voltage downlight, plan the layout around your transformer capacity and the wattage of the G4 lamps you choose. As an IP20 fitting it is for dry indoor use only, so keep it clear of bathrooms, porches and any damp or sheltered-outdoor positions.

Built from steel with a chrome finish, the Gavi has a clean round trim that reads well in modern interiors. It is a 12V fitting, so it needs a suitable low-voltage transformer or driver sized to the total load of the lamps on the circuit, rather than wiring direct to mains. The fitting recesses into the ceiling through a cut-out, with the chrome bezel sitting flush against the surface. It is rated IP20 for dry indoor locations. The Gavi sits within a wider range of downlights, so matching fittings are available across other wattages and finishes.

What size cut-out does the Gavi need?

The fitting has an overall round diameter of 73mm and recesses into the ceiling, so allow a cut-out sized to the manufacturer's template rather than the full 73mm trim diameter. The chrome bezel then sits flush over the opening. Always check the clearance depth above the ceiling before cutting.

Does the Gavi need a transformer?

Yes. It is a 12V low-voltage downlight (12 AC or 12 DC), so it must run through a suitable transformer or driver rather than connecting straight to mains. Size the transformer to the combined wattage of all the G4 lamps on the circuit, allowing for the 10W maximum per fitting.

How many should I use in a room?

As a focused low-voltage downlight, several are usually spaced across a ceiling to build an even spread rather than relying on one. The right number depends on room size, ceiling height and the G4 lamp output you choose, so plan the spacing to avoid dark patches between fittings.

How do I clean the fitting?

Wipe the chrome trim with a soft, dry or slightly damp cloth once the fitting is switched off and cool. Avoid abrasive cleaners or solvents, which can mark the chrome surface. A gentle wipe is enough to keep the bezel looking fresh.