FL AGOR AIO 200W Colour Selectable Floodlight 90 deg IP65 - Black

The AGOR AIO is a high-output LED floodlight with selectable power across 100, 150 and 200W, delivering 14250, 20950 and 27550 lumens respectively from a single fitting. American buyers will recognise it as an outdoor LED flood light for security and area lighting. Running on 220-240V AC, it casts a wide 90 degree spread and is colour selectable across three tones, 3000K warm white, 4000K neutral white and 6000K daylight, set on the fitting to match the look of the site.

Built for outdoor work, this floodlight suits car parks, yards, loading bays, building façades and large driveways where a single bright source needs to cover an open area. The 90 degree beam throws a broad, even wash rather than a tight long-distance spot, so it is best mounted at height and angled down to flood the ground below. At full 200W it puts out 27550 lumens, which roughly equates to a 1400W traditional halogen floodlight, so it replaces several older fittings with one efficient unit while cutting running costs sharply.

The housing is metal in a black finish, rated IP65 against dust and water jets for fully exposed positions, and carries an IK08 impact rating for durability on busy commercial sites. It runs direct from mains AC and is not dimmable, with the colour temperature and power level selected at install. The fitting mounts to a wall or ceiling and weighs 5.07 kg, with a rated lifespan of 50,000 hours. This floodlight sits within our wider Kanlux outdoor range alongside lower-wattage AGOR options for smaller areas.

How bright is this floodlight and how much area does it cover?

At its full 200W setting it produces 27550 lumens, with lower 20950 lm and 14250 lm options at 150W and 100W. The wide 90 degree beam spreads light over a large open area such as a yard or car park, so mount it high and angle it down for the broadest coverage.

What halogen wattage does it replace?

At 27550 lumens the 200W setting roughly matches a 1400W traditional halogen floodlight, since older halogen units produce around 20 lumens per watt. Even at the 100W setting it outperforms a typical 700W halogen, so one fitting can replace several old lamps while using far less power.

Is it suitable for outdoor and wet locations?

Yes. It carries an IP65 rating, which means it is protected against dust and low-pressure water jets, so it is suitable for fully exposed outdoor positions. The IK08 impact rating adds robustness for commercial and industrial sites.

How do I keep it clean?

Switch off the supply and allow the fitting to cool, then wipe the front glass and black housing with a soft damp cloth. Clearing dust and grime from the lens keeps the light output at its best, and avoid abrasive cleaners that could scratch the surface.