TP SLIM 40W N SLIM NW 1240x40 IP65 Batten 145110 deg Cool White - White

The TP SLIM is a slimline LED batten that draws 40W and puts out 4800 lumens at a steady 4000K cool white, giving a crisp, neutral light across its 1240mm length. The asymmetric optic spreads the beam at 145° × 110°, washing a wide area below rather than throwing a tight spot. Buyers in the US will recognise this format as an LED shop light, the linear strip fixture commonly run along garage and workshop ceilings, and it is sometimes called a wraparound light for the same reason. The fixed colour temperature keeps the output consistent from one end of a run to the next.

At 4800 lumens this single batten covers around 16 m² at general lighting levels, which makes it a sensible single-fitting choice for a one-car garage, a small workshop, a store room or a utility area. Because the body is rated IP65 it can also be mounted in genuinely damp and exposed spots, such as a car park, a covered loading bay or an outbuilding where moisture and dust are a concern. The slim 1240mm profile sits close to the ceiling or wall without intruding into headroom, and several units can be set out in a line to light a longer space evenly. The 145° spread means the light reaches into corners better than a narrow fixture would.

The housing is plastic with a white finish and carries an IP65 weatherproof rating, sealing the LEDs against rain, jets and airborne dust so it holds up in wet and dirty environments. It can be fixed flush to a ceiling or a wall using the supplied brackets, and the integrated LEDs run direct from 220-240V AC mains. The fitting is not dimmable and is built around a 50,000 hour rated lifespan. We stock the wider TP SLIM range in matching lengths and wattages, so a whole space can be fitted out in one consistent style.

Where is this batten typically used?

It suits garages, workshops, store rooms, car parks and damp utility areas where a bright, even strip of light is needed. The IP65 rating means it can also go in exposed and wet locations that would not suit a standard indoor fitting. The 4000K cool white output keeps work areas clearly lit.

Is it suitable for outdoor and wet locations?

Yes. With an IP65 rating it is sealed against water jets and dust, so it can be mounted outdoors, in covered loading bays and in damp outbuildings. It withstands rain and washdown conditions without water ingress to the LEDs.

Can several be linked in a run?

Multiple units can be installed in a line along a ceiling or wall to light a longer space evenly. Each fitting runs from the 220-240V AC mains supply and is fixed with its own brackets. Spacing them by output keeps the light level consistent across the area.

How do I clean and maintain it?

Wipe the white body and diffuser with a soft, damp cloth and a mild detergent, avoiding solvents that could mark the plastic. Make sure the fitting is switched off and the surface is dry before restoring power. The sealed IP65 housing means dust and moisture stay outside, so cleaning is occasional.