BLINGO UIP 1200x300 40W Recessed LED Panel Driverless 90 deg 125LM120NW Cool White - White

The Blingo UIP is a recessed LED panel measuring 1195 x 295 x 26 mm, drawing up to 40W and producing 3000, 4000 or 5000 lumens depending on the wattage step, at a 4000K cool white tone. In the US this is a 1x4 troffer format, sized to drop into a standard suspended-ceiling grid. The 90 degree beam spreads an even wash across the room rather than a narrow pool, and with efficiency up to 125 lm/W it delivers strong output for the power it consumes. A Ra 90 colour rendering keeps tones looking natural under the light.

The slim rectangular shape suits offices, retail floors, reception areas and similar commercial rooms, where it covers around 10 to 17 m² at general lighting levels at full output. Because it recesses into the ceiling, allow clearance in the void above so the panel sits flush within the grid; it works best in ceilings with a drop or suspended grid layout rather than a solid plasterboard finish. Its IP54 rating means it tolerates splashes and sheltered positions such as bathroom zones, a covered porch or a carport, though it should be kept clear of fully exposed locations, direct water jets and any submersion.

The body is steel with a white finish, holding the panel rigid across its length. As a driverless type it runs direct from mains AC, so no separate driver or transformer is needed to install it, which simplifies the wiring at the ceiling. The IP54/20 rating reflects the splash-resistant front and the standard rear, and the rated lifespan is 50,000 hours. It weighs 1.60 kg and mounts recessed into the ceiling grid. This panel sits within the wider Blingo range, which includes further sizes and output options.

Is this LED panel dimmable?

As a driverless panel it runs direct from mains AC, so it is not dimmable as supplied. Dimming would require a compatible mains-dimmable arrangement, which this driverless type is not configured for. For office and retail use it is intended to run at full output.

Does it need a separate driver?

No. This is a driverless panel, meaning it runs straight from the mains AC supply with no external driver or transformer to source or wire in. You connect it directly at the ceiling, which keeps the installation simpler than a remote-driver panel.

Will it fit a standard suspended ceiling grid?

Yes. At 1195 x 295 mm it suits a 1x4 grid module and recesses into the ceiling void, sitting flush within the framework. Make sure there is enough clearance above the grid for the 26 mm depth plus the cabling.

How do I clean the diffuser?

Switch the panel off and let it cool, then wipe the diffuser with a soft, dry or barely damp lint-free cloth. Avoid solvents and abrasive pads, which can mark the surface. A light wipe now and then keeps the light output even across the face.