Description
Tilt is a chandelier in black and brass. Two black rings crossed at right angles: a large horizontal circle carrying a continuous strip of light round its inner face, and a taller arch standing up through it, hung from a single black flex. The lit strip runs the whole way round the horizontal ring, so the fitting reads as a drawn circle of light with a loop of black above it. Small brass collars mark where the arch passes through the ring and where the flex enters. The metal is a flat matt black and the sections are slim, so the outline stays thin. Nothing is shaded and the ring is the whole of the light. It measures 40cm across and 33cm tall, in metal.
It suits a dining table or a hall with height above head level, where the arms are read as a shape rather than crowded against a ceiling. It hangs on 300cm, cut to the drop at installation rather than fixed at the factory.
The LED is built in at 30W, so there is no bulb to buy and none to fit. It has 3 brightness settings, at 100%, 50% and 25% of output, changed by switching off at the wall and straight back on, so no dimmer is needed. The driver remembers whichever level you last left it on. It is rated IP20, for dry indoor rooms. It carries a G energy label.
Specification
| Diameter |
40cm |
| Height |
33cm |
| Finish |
Black & Brass |
| Material |
Metal |
| Light Source |
Integrated LED |
| Power |
30W |
| Brightness Settings |
100%, 50% and 25% |
| Output by Setting |
995 lm, 545 lm, 100 lm |
| Setting Memory |
Yes |
| Energy Class |
G |
| Cable |
300cm textile |
| IP Rating |
IP20 |
| Suitable Location |
Indoor, dry rooms |
Downloads
Instruction manual (PDF)
Frequently Asked
Do I need to buy a bulb?
No. The LED is built into the fitting, so there is nothing to buy and nothing to fit.
What happens when the LED fails?
The fitting is replaced rather than relamped. At 30W and normal domestic use that is many years away.
How do I change the brightness?
Switch off at the wall and straight back on. Each flick moves it to the next setting, at 100%, 50% and 25%. No dimmer is needed, and it remembers the level you leave it on.
Will it work on a dimmer?
It does not need one, and it should not be fitted to one. Brightness is controlled from the wall switch instead.
How bright is it at full?
Comparable to a 75W incandescent bulb at full, with the lower settings for evenings and a night light.
How high should it hang above a dining table?
About 80cm from the table top to the bottom of the lowest lamp. Go higher over an island people walk past, and lower over a table nobody passes beneath.