Description
Cast concrete in a white finish gives this little spotlight a solid, quarried look that sits well against timber, brick and render alike. The body is a neat block, 90mm square at the face and 130mm deep, with the lamp set back at the open end so the source stays out of your eyeline. It takes a GU10 reflector lamp, and where a dimmable lamp is paired with a compatible dimmer the level can be brought down.
Sealed against water and dust, it is at home on an exposed wall or tucked under a porch soffit, throwing a controlled cone rather than general light. We reach for it where a wall light would look fussy: over a front door, above a garage, picking out a specimen tree or washing the face of a stone wall. It suits anyone who wants light aimed exactly where it is needed rather than spilled about, and indoors it does the same job in a shower room or a utility. Run several along a soffit and you get an even rhythm of pools down a path.
Concrete is an honest, weighty material, and each casting carries its own faint variation across the surface, which is part of the appeal. Keep it clean with a soft damp cloth and dry it off afterwards, leaving abrasive creams and solvents well alone, because the finish is meant to read as raw material rather than paint. It carries a two year warranty. We stock the same rectangular spotlight in grey concrete, a round spotlight in both shades, and rectangular and round wall lights if you want one look running across a whole elevation. Lamps are not included.
Specification
| Colour |
White Concrete |
| Ceiling Mountable |
Yes |
| Weight |
1.20KG |
| Length |
90mm |
| Width |
90mm |
| Height |
130mm |
| Materials Used |
Concrete |
| Adjustable Height |
No |
| Hanging Method |
Bracket |
| Energy Class |
A++ to B |
| Max Energy Class |
A++ |
| Min Energy Class |
B |
| Lamp |
1 x GU10 12W max (lamps not included) |
| Lamp Cap |
GU10 |
| Recommended Lamp |
LED (50mm Reflector) |
| Light Distribution |
Down |
| Protection Class |
Class 1 - Earth Connection Required |
| Total Power Consumption (W) |
Dependent On Lamps Used (±5%) |
| Input Voltage (V) |
100-240V~50/60Hz |
| Dimmable |
Yes - Dimmable Lamps Required |
| Dimmer Included |
No |
| IP Rating |
IP65 |
| Warranty |
2yrs |
| UKCA/CE |
Yes |
| Pieces Included |
1 |
| Unassembled |
No |
| Installation |
Requires Installation By Qualified Electrician |
| Product Care |
(1) Wipe clean with a dry cloth, do not use any cleaning detergents, do not use rough or coarse material to clean. (2) Ensure light is not illuminated when cleaning. |
| Country of Origin |
China |
Frequently Asked
What lamp does it take?
One GU10 lamp up to 12W. An LED reflector of 50mm diameter is the recommended choice.
Can it be dimmed?
Yes, provided you fit a dimmable GU10 lamp and pair it with a suitable dimmer switch. No dimmer is supplied with the spotlight.
How big is it?
The face measures 90mm by 90mm and the body is 130mm deep. It weighs 1.2kg.
Is it suitable for outdoor use?
Yes. It is rated IP65, so it copes with rain and dust in open garden and entrance positions as well as sheltered ones.
How should the concrete be cleaned?
A soft cloth, damp rather than wet, then dry it off. Avoid scouring pads, bleach and solvent cleaners, which will mark the surface.
Does the finish vary between units?
Slightly. Concrete is cast, so small differences in tone and texture are normal and settle in once the fitting is up.