Bano Small LED Crystal Chain Wall Light - French Gold

The Bano is a 300mm-wide wall light built around a rectangular French gold backplate from which multiple strands of faceted crystal buttons cascade in varying lengths, creating a waterfall effect against the wall. An integrated 6W LED inside the backplate illuminates the crystals from above, refracting light through each faceted surface and casting scattered reflections across adjacent surfaces.

Designed for hallways, bedroom accent walls, and living room alcoves where decorative wall lighting adds both task and ambient function, the Bano works as a single fitting or in symmetrical pairs flanking a mirror, doorway or artwork. The 90mm projection from the wall and 280mm drop give the fitting enough visual presence to anchor a wall section without overwhelming narrow hallways or bedside positions. The dimmable LED allows the light output to be adjusted from full 660lm brightness down to a low-level glow, though a compatible trailing-edge LED dimmer is required.

The French gold finish carries a warmer, slightly aged tone compared to polished brass, pairing well with warm neutrals, cream walls and interiors where antique brass or bronze fixtures are already present. The double-layered arrangement of crystal strands gives the fitting more density and depth than single-layer alternatives, with each strand terminating in a larger teardrop crystal. The 4000K cool white colour temperature sits between warm white (3000K) and daylight white (5000K), producing a clean neutral light that works across both warm and cool colour schemes.

Is the Bano dimmable?

Yes. The integrated LED is dimmable, but requires a compatible trailing-edge LED dimmer switch. Standard rotary or slider dimmers designed for incandescent bulbs may cause flickering or not work at all. Check dimmer compatibility before installation.

What colour temperature is the LED?

The integrated LED runs at 4000K cool white, which sits between warm white (3000K) and daylight white (5000K). This produces a clean neutral light that works across both warm-toned and cool-toned interiors without adding a yellow or blue cast.

How are the crystals cleaned?

Switch off the fitting at the mains and allow it to cool. Dust the crystal strands with a soft microfibre cloth or a clean, dry paintbrush. For more stubborn marks, lightly dampen the cloth with distilled water and wipe each crystal individually, then dry immediately to prevent water spots.

Can this be installed in a bathroom?

The Bano carries no IP rating in the specification, which means it is designed for dry interior use only. It should not be installed in bathrooms or other areas where it may be exposed to moisture or steam.