Lucenza LED 2 Tier Halo Ring Alabaster Chandelier - Brushed Brass

The Lucenza is a two-tier halo ring chandelier built from an 800mm upper ring and a 400mm lower ring, each formed from segmented natural Spanish alabaster blocks set into a brushed brass channel. Integrated 3000K LED strips run inside both rings on a 230V supply, casting warm soft-white light downward through the alabaster and outward across the brass band. The full assembly suspends from a single brushed brass ceiling canopy on adjustable steel cables.

Designed for double-height rooms, entrance halls, stair voids and large dining or living spaces, the chandelier reads best in ceilings of 3m or higher where the staggered ring arrangement has room to breathe. The 1500mm cable drop is adjustable on installation, allowing the upper ring to sit closer to the ceiling and the lower ring to hang at table or eye level. The ring composition gives 360-degree visual interest, so the chandelier works equally well over a round dining table or in the centre of an open stairwell viewed from multiple floors.

The alabaster segments are cut from natural stone and slotted into the brass frame in a vertical staggered pattern, which catches and softens the LED light along the entire circumference. Veining and tonal variation differ between segments, so each ring has its own grain pattern when illuminated. The brushed brass finish on the inner and outer band of each ring adds a warm metallic line above and below the alabaster, balancing the cool translucency of the stone against a richer warm tone.

What ceiling height is required?

The Lucenza is best suited to rooms with ceilings of 3m or higher, such as double-height halls, stairwells and large open-plan spaces. The 1500mm cable drop is adjustable on installation, so the chandelier can be raised for slightly lower ceilings or lowered further over a dining table.

Is the chandelier dimmable?

The integrated LED runs on 230V mains. Dimmer compatibility depends on the specific dimmer model, so please contact us before pairing with a dimming circuit to confirm a suitable match.

Does the alabaster vary between pieces?

Yes. Each segment is cut from natural Spanish alabaster, so veining, mineral tone and translucency differ between individual blocks within the rings. This is a feature of the natural stone and gives each chandelier its own grain pattern when lit.

How are the alabaster segments cleaned?

Alabaster is porous and softer than marble. Wipe gently with a dry, soft microfibre cloth. For more stubborn marks a barely-damp cloth with distilled water is acceptable, but avoid soaking the stone and do not use household sprays, polishes or chemical cleaners on either the alabaster or the brushed brass channel.