Description
The Valeris 120cm is the longest fitting in the range, a linear chandelier built from layered panels of natural Spanish alabaster set around a brass frame and lit internally by an 80W integrated LED. The panels sit in a staggered two-tier arrangement, giving a level upper line and a stepped lower edge that breaks up the length of the bar. A rounded rectangular brass canopy carries the fitting on four slender cables and holds the 35cm-wide body level across its full 120cm span.
At 120cm the Valeris is proportioned for dining tables and kitchen islands of roughly 180cm to 240cm, where a shorter fitting leaves the ends of the table underlit. Rooms with ceilings of 2.6m or higher suit it best, and the cable suspension is adjustable on installation so the bar can be set 75-85cm above the surface it lights.
Each panel is cut from solid stone, so veining, translucency and mineral density differ from panel to panel and from one fitting to the next. Lit from inside, the alabaster carries the light rather than blocking it, and the staggered layout throws soft vertical shadows down the length of the bar. The brass frame and canopy are lightly brushed, picking up the cream and off-white tones in the stone without competing with them.
Because the LED is integrated there is nothing to buy and nothing to fit, and output stays even from one end of the bar to the other. Over a long table that reads more cleanly than a row of separate pendants, where the dark gaps between fittings fall across the middle of the table.
Specification
| Material |
Brass & Natural Spanish Alabaster |
| Finish |
Soft White & Brass |
| Height |
14cm |
| Length |
120cm |
| Width |
35cm |
| Wattage |
80W LED |
| Warranty |
2 Year |
Frequently Asked
Does the Valeris need bulbs?
No. The 80W LED is integrated into the fitting and is not a replaceable lamp, so no bulbs are required. It arrives ready to wire in.
Is it dimmable?
Dimmer compatibility depends on the dimmer model used with the integrated LED driver. Please contact us before wiring the Valeris into a dimmed circuit so we can confirm suitability for your installation.
Should I choose the 100cm or the 120cm?
Match the fitting to the surface below it: the chandelier should sit at roughly half to two-thirds the length of the table or island. The 120cm suits tables of about 180-240cm, and the 100cm suits 150-200cm. Where a table falls in the overlap, the longer bar reads better in a wide room and the shorter one in a narrow one.
What ceiling height is needed?
Ceiling heights of 2.6m or higher allow the fitting to be hung 75-85cm above a dining or island surface, which is the typical range for linear chandeliers of this depth. The cable suspension is adjustable on installation to set the final drop.
Will the alabaster look identical to the photograph?
The overall form, dimensions and finish match the photograph, but each panel is cut from natural Spanish alabaster and shows different veining, tonal variation and translucency. This is a feature of the natural material rather than a defect.