Sola 0.8W Recessed LED Step Light Cool White - Steel

The Sola is a recessed LED step light that sits flush in the wall to mark a low-level edge with a soft downward glow. It draws just 0.8W at 12V DC and gives 14 lumens at 4000K, a crisp cool white tone that reads clearly against treads, skirtings and hallway walls. The round face measures Ø70 mm and stays low key in the daytime, doing its work once the surrounding light drops. Buyers in the US will recognise the format as a recessed wall step light, the kind set into a staircase wall to wash light across the step below.

The light suits indoor stairs, landings, hallways and corridors where a guiding marker matters more than general illumination. Because the output is deliberately low, it is best read as wayfinding rather than room lighting, so a single fitting picks out one step or a short stretch of floor, and a run set at consistent heights guides the eye along a flight or passage. With an IP20 rating it is built for dry interior positions only, so keep it clear of bathrooms, porches and any exposed or damp setting. Recessing into the wall keeps the body hidden, leaving only the trim visible at the surface.

Build is polished stainless steel with a plastic body behind the face, finished in steel for a clean metallic edge that holds up to handling on a busy staircase. The fitting runs on 12V DC, so it needs a suitable low-voltage supply rather than connecting straight to mains, and the integrated LED is rated for 50,000 hours with a CRI of Ra 80. It mounts recessed into the wall and is not dimmable. The Sola range covers further low-level markers in this style for matching a stairwell or corridor scheme.

Does it need a 12V transformer or driver?

Yes. The Sola runs on 12V DC, so it must be fed from a suitable low-voltage driver or transformer rather than wired direct to mains. Each 0.8W fitting draws very little, so several can share one appropriately rated supply.

Is it suitable for outdoor or bathroom use?

No. With an IP20 rating it is rated for dry indoor use only. Keep it to stairs, landings, hallways and corridors, and out of bathrooms, porches and any damp or exposed location.

How is it installed?

It recesses flush into the wall, so the Ø70 mm body sits behind the surface and only the round trim shows. Set fittings at a consistent low height along a flight or corridor for an even guiding effect.

How do I clean it?

Wipe the polished stainless steel face with a soft, slightly damp cloth and dry it off, avoiding abrasive pads that could mark the finish. As an indoor IP20 fitting it should be cleaned dry, without water being directed at it.