Sabik 0.8W PIR LED Step Light 12V Cool White - Black

The Sabik is a recessed LED step light with a built-in PIR sensor, drawing just 0.8W from a 12V DC supply to put out 14 lumens at a crisp 4000K cool white. American buyers will recognise this format as a recessed stair light, set flush into the wall to mark a step edge rather than to light a whole space. The square face measures 75 mm across and the body sits within the wall, so only the front plate shows once installed. The PIR triggers the light as someone approaches, then lets it switch off again, which keeps the fitting unobtrusive on a quiet staircase or landing.

Designed for indoor stairways, the Sabik suits the side wall of a staircase, a hallway threshold or a split-level landing where a low marker light makes each step easier to read in the dark. The output here is deliberately small, so think of it as edge marking and a soft wash across the tread directly below rather than general room lighting. Spacing several units down a flight gives a clear run of guide points. The cool white tone reads as a clean, modern accent against the black face and pairs well with contemporary stair finishes.

Built around a 75 × 23 × 75 mm body in polished stainless steel and plastic, the Sabik weighs only 88 g and recesses into the wall via a matching cut-out, sitting almost flush once fitted. It runs on 12V DC, so a suitable low-voltage driver is needed, and it is not dimmable. The IP20 rating means it is for dry indoor use only, so keep it clear of bathrooms and any outdoor or damp location. The LED is rated to 50,000 hours and the finish is black. This range includes further Sabik step lights in other tones.

Does it need a 12V transformer or driver?

Yes. The Sabik runs on 12V DC, so it must be wired to a suitable low-voltage driver rather than connected directly to the mains. Size the driver to cover the total wattage of every step light on the run, with each unit drawing just 0.8W.

Can it be used outdoors?

No. The Sabik is rated IP20, which is for dry indoor use only. Keep it out of bathrooms, porches and any outdoor or damp setting, and reserve it for interior staircases, hallways and landings.

How is it installed?

It is a recessed wall fitting, set into a cut-out in the side wall of a staircase so the square face sits almost flush. The compact 75 × 23 × 75 mm body and 88 g weight make it easy to position at a consistent height down a flight.

How do I clean it?

Wipe the front plate with a soft, dry or barely damp cloth and avoid solvents or abrasive cleaners, which can mark the finish. As an IP20 indoor fitting, it should not be exposed to running water during cleaning.