LED Rope Light 5m 10W IP65 Outdoor Decorative - Green

This LED rope light is a round, flexible encased tube that throws a continuous green glow along its full 5 metre length. It draws 10W in total and gives 145 lm, with the diodes sealed inside a 13 mm diameter polymer tube rather than sitting on an open reel. Sold in the US as led rope light or light strip, it is fed through its own connection kit rather than being cut at intervals like a bare led tape. The even, dot-free line of colour makes it a decorative run instead of a task or ambient source.

Its strength is outlining and edging rather than lighting a room, so it suits eaves, balconies, fascia boards, pergolas, railings and event or display borders where a clean green line is wanted. The flexible tube bends around corners and follows curved profiles, and because the throw is decorative the coverage is best judged by the length of run you need to trace rather than any floor area. A single 5 metre length traces a long edge in one piece, and the warm-toned alternatives in the range cover other accent jobs around the same outline.

The tube carries an IP65 rating, so it copes with exposed outdoor and wet locations including direct rain along an open eave or fence line. It runs on a 210V DC supply through its supplied connection kit, so it is wired via that feed rather than plugged straight into a wall socket, and the rated life is 15,000 hours. The whole 5 metre run weighs 794 g, keeping clip or cable-tie fixing simple along a long edge. Other colours and lengths are offered across the range for matching wider decorative schemes.

Product Specification Sheet

Range Datasheet

Can this rope light be used outdoors in the rain?

Yes. It carries an IP65 rating, which means it is weatherproof and suitable for exposed outdoor and wet locations such as eaves, fences and balconies. It will cope with direct rain along an open run.

Can I cut this rope light to length?

Unlike a bare LED tape, this is a sealed encased tube fed through its own connection kit, so it is supplied as a fixed 5 metre length rather than cut at marked intervals. Plan your run around the 5 metre length and join further sections through the kit where the system allows.

How do I power this rope light?

It runs on a 210V DC supply through its supplied connection kit, so it is wired via that feed rather than plugged directly into a wall socket. Use the matching connection and end caps to keep the IP65 seal intact.

How do I clean the rope light?

Wipe the tube down with a soft, damp cloth and dry it off, working along the length while the light is switched off and disconnected. Avoid harsh solvents so the clear outer tube stays clear and the green output is not dulled.