Description
The Astim is a surface-mounted LED downlight that pushes 910 lumens from a 12W integrated board, running direct from 220-240V AC mains. The light is a neutral 4000K white at Ra 80, spreading through a wide asymmetric beam of 120 degrees by 105 degrees. American buyers will know this rectangular surface fitting as a low-profile recessed can light alternative, sitting proud of the ceiling rather than dropping into it. The slim 600 x 100 mm body keeps the fixture flat against the surface while the broad spread softens shadows below.
The wide beam suits compact rooms where a single fitting needs to cover the floor evenly, lighting around 3 m² at general lighting levels. It works well over a bathroom area, a hallway or a small utility space, and its splash-resistant rating means it can sit in covered or sheltered positions too. For ceiling heights of roughly 2.4 to 2.7 metres the throw stays balanced, and the elongated rectangular shape lets it run along a corridor or above a vanity better than a round fitting would. Several units can be lined up to wash a longer ceiling.
Built from aluminium alloy in a black finish, the Astim carries an IP44 rating, so it copes with splashes and condensation without being exposed to direct jets or weather. It is surface mounted, fixing flat to the ceiling with no cut-out required, which makes it a tidy retrofit where recessing is not possible. The driver is integrated, the fitting is non-dimmable, and the LED is rated for 25,000 hours. This Kanlux model joins a wider Astim range of matching surface downlights.
Specification
| Power |
12W |
| Voltage |
220-240 AC |
| Luminous flux |
910 lm |
| Efficiency |
76 lm/W |
| Colour temperature |
4000K |
| Colour rendering (CRI) |
Ra 80 |
| Beam angle |
X120/Y105° |
| IP rating |
IP44 |
| Dimmable |
No |
| Mounting |
Surface Mounted |
| Lifespan |
25,000 hours |
| Shape |
Rectangular |
| Dimensions |
600 × 100 × 44 mm |
| Weight |
234 g |
| Material |
Aluminium Alloy |
| Finish |
Black |
Downloads
Frequently Asked
Is this downlight dimmable?
No, the Astim is a non-dimmable fitting and should be run on a standard switched circuit. Pairing it with a dimmer is not recommended, as this can cause flicker or shorten the life of the integrated LED.
Does it need a cut-out hole in the ceiling?
No cut-out is needed. This is a surface-mounted fixture, so it fixes flat against the ceiling rather than dropping into a recessed hole, which makes it ideal for solid ceilings or anywhere recessing is not practical.
Can it be used in a bathroom?
Yes, the IP44 rating makes it splash-resistant and suitable for bathroom zones away from direct water contact. It also works in covered outdoor spots such as a porch or carport, but it should not be exposed to direct water jets or full weather.
How do I clean the fitting?
Wipe the surface and lens with a soft, dry or slightly damp cloth once the light is switched off and cool. Avoid abrasive cleaners or solvents, as these can mark the black aluminium finish over time.