Description
This Knightsbridge 24V LED strip light delivers 590 lumens per metre at 6000K daylight colour temperature, sealed inside a silicone extrusion rated IP67 for full immersion protection. The 5-metre reel carries 64 surface-mount 2835 LEDs per metre and draws 4.8W per metre on 24V DC supply. The strip cuts every 125mm along marked sections, allowing custom lengths to be installed without wasting material.
Designed for both internal and external installations where waterproofing is needed, the IP67 rating allows the strip to be used in bathrooms, wet rooms, under kitchen worktops, garden decking lighting, architectural façade wash, and outdoor feature lighting. The 10mm width (12mm including end caps) fits into narrow aluminium profiles and recessed channels. The strip ships with 3M self-adhesive tape on the reverse, though separate mechanical fixings (FLEXFIX) are available where adhesive alone is insufficient.
The 6000K colour temperature produces a crisp daylight white that suits task lighting, worktop underlighting, and outdoor security applications where cooler tones are preferred over warm white. The strip requires a separate 24V constant voltage driver (sold separately) sized to match total wattage — a 5m reel draws 24W, so a 30W driver would allow headroom for safe operation. Dimming is possible when paired with a compatible driver and dimmer controller. The maximum continuous run is 20 metres before voltage drop becomes noticeable.
The silicone encapsulation protects the LEDs and circuit board from dust and water ingress while maintaining flexibility for bending around curves and corners during installation. IP end caps (LFCFIX10, sold separately) seal the cut ends after installation to maintain the IP67 rating. The L70B50 rating of 54,000 hours indicates the point at which 50% of LEDs will have degraded to 70% of their initial light output — approximately 6 years of continuous use.
Specification
| Length |
5000 mm |
| Width |
10 mm |
| Projection |
7 mm |
| Class |
III |
| IP Rating |
IP67 |
| Primary Voltage |
24V DC |
| Lamp Technology |
LED |
| Lamp Included |
Yes |
| Dimmable |
Driver dependent |
| L70B50 |
54000 |
| Energy Rating (Class) post 2021 SLR |
E |
| Beam Angle |
120 |
| CCT |
6000 K |
| Light Colour |
Daylight |
| Lumens |
590 lm |
| Wattage |
4.8 |
| Efficacy |
137.54 lm/W |
| CRI |
>80 |
| Warranty |
3 |
Downloads
Product Specification Sheet
Frequently Asked
What driver does this strip need?
The 5m reel draws 24W (4.8W per metre), so a 24V constant voltage driver rated at 30W or higher is recommended to allow safe operating headroom. Drivers are sold separately — search for Knightsbridge 24V drivers on the site.
Can it be cut to a shorter length?
Yes. The strip has marked cut points every 125mm. Cut along the marked line with sharp scissors, then seal the cut end with an IP end cap (LFCFIX10, sold separately) to maintain the IP67 rating.
Is it dimmable?
Dimming depends on the driver and controller used. Pair the strip with a dimmable 24V driver and a compatible dimmer controller (both sold separately) to achieve smooth dimming. Not all 24V drivers support dimming — check the driver specification before purchasing.
Can it be used outdoors?
Yes. The IP67 rating allows full immersion in water up to 1 metre depth for short periods, making it suitable for outdoor garden lighting, architectural façade wash, and deck lighting. Seal all cut ends with IP end caps and ensure the driver is housed in a weatherproof enclosure.